Special features of your oven control. GEAppliances.comFahrenheit or Celsius Temperature SelectionYour oven control is set to use the Fahrenheittemperature selections, but you may change thisto use the Celsius selections.Touch the upper oven BROIL HI/LO andBAKE pads at the same time until the displayshows SF.Touch the COOK TIME and BROIL HI/LOpads at the same time. The display will showF (Fahrenheit).Touch the COOK TIME and BROIL HI/LOpads again at the same time. The display willshow C (Celsius).Touch the START pad.Tones at the End of a Timed CycleAt the end of a timed cycle, 3 short beeps willsound followed by one beep every 6 secondsuntil the CLEAR/OFF pad is touched. Thiscontinual 6-second beep may be cancelled.To cancel the 6-second beep:Touch the upper oven BROIL HI/LO andBAKE pads at the same time until thedisplay shows SF.Touch the BROIL pad. The display showsCON BEEP (continuous beep). Touch theBROIL pad again. The display shows BEEP.(This cancels the one beep every 6 seconds.)Touch the START pad.Your new touch pad control has additional features that you may choose to use. The following are the features and howyou may activate them.The special feature modes can only be activated while the display is showing the time of day. They remain in the control’smemory until the steps are repeated.To enter a special feature for either oven, you must first touch the upper oven BROIL HI/LO and BAKE pads at the sametime. The lower oven BROIL HI/LO and BAKE pads will not activate special features.When the display shows your choice, touch the START pad. The special features will remain in memory after a powerfailure, except for the Sabbath feature, which will have to be reset.Tone VolumeThis feature allows you to adjust the tonevolumes to a more acceptable volume. Thereare three possible volume levels.Touch the upper oven BROIL HI/LO andBAKE pads at the same time until thedisplay shows SF.Touch the COOK TIME pad. The display willshow STD BEEP. This is the middle volumelevel.Touch the COOK TIME pad again. Thischanges the volume level each time thepad is touched, and a tone will sound toprovide an indication of the volume level.Choose the desired sound level (LO BEEP,STD BEEP, HI BEEP, or OFF).Touch the START pad to activate the levelshown.25