GE JB940 Owner's Manual

Also see for JB940: Installation instructions Installation instructions Owner's manual Owner's manual Technical service guide

GE JB940 Owner's Manual Manual pdf 29 page image

Safety Instructions Operating InstructionsSafety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Customer ServiceOven Light ReplacementCAUTION: Before replacing your oven light bulb,disconnect the electrical power to the range atthe main fuse or circuit breaker panel.Be sure to let the light cover and bulbcool completely.To remove the cover:Hold a hand under the cover so itdoesn’t fall when released. Withfingers of the same hand, firmlypush back the wire cover holder.Lift off the cover.Do not remove any screws to removethe cover.Replace bulb with a 40-wattappliance bulb.To replace the cover:Place it into groove of the lightreceptacle. Pull wire forward tothe center of the cover until it snapsinto place.Connect electrical power to the range.Wire cover holder.Broiler Pan & GridDo not clean the broiler pan or grid in a self-cleaning oven.After broiling, remove the broiler panfrom the oven. Remove the grid from thepan. Carefully pour out the grease fromthe pan into a proper container.Wash and rinse the broiler pan and grid in hotwater with a soap-filled or plastic scouring pad.If food has burned on, sprinkle the gridwith detergent while hot and cover withwet paper towels or a dishcloth. Soakingthe pan will remove burned-on foods.Both the broiler pan and grid may be cleaned witha commercial oven cleaner.Both the broiler pan and grid can also becleaned in a dishwasher.Do not store a soiled broiler panand grid anywhere in the range.Oven Heating ElementsDo not clean the broil element. Any soilwill burn off when the element is heated.To clean the oven floor, gently lift thebake element. Clean with warm,soapy water.On some models, the bake element is notexposed and is under the oven floor. If spillovers,residue or ash accumulate on the oven floor, wipeup before self-cleaning.29Storage Drawer RemovalTo remove the drawer:Pull the drawer out until it stops.Lift the front of the drawer until thestops clear the guides.Remove the drawer.To replace the drawer:Place the drawer rails on the guides.Push the drawer back until it stops.Lift the front of the drawer and pushback until the stops clear the guides.Lower the front of the drawer andpush back until it closes.Stop guideRail