GE JBP19 Use And Care & Installation Manual

Also see for JBP21: Owner's manual Owner's manual and installation instructions Specifications Owner's manual and installation instructions Owner's manual and installation instructions

GE JBP19 Use And Care & Installation Manual Manual pdf 12 page image

OVEN CONTROL, CLOCK AND TIMER(continued)Power OutageOn some models, after a power outage the oven will If your model has a COOK TIMEautomatically resume its setting once power is ON/OFF pad and your oven was set forrestored. timed baking or roasting when the powerFor models with a CLOCK pad, whenthe power is restored the display will flash“PF” for Power Failure until a pad ispressed or the knob is turned. Reset the o outage occurred, the clock and all o1 ?!:!ONIOFFprogrammed functions must be reset. To reset them,CLOCK first turn the Oven Temperature knob back to OFF,reset the clock, functions and knob back to the wayclock to the correct time of day. they were before the power outage.If the oven was in operation when the power outageoccurred, the Oven Temperature knob must be turnedback to OFF. Then reset the knob to the way it wasbefore the power outage.End of Cycle Tonen End of cycle tone can be cleared by~ VAMOFFER pressing the TIMER ON/OFF pad,o or, on other models, by pressing the, ~~~~ COOK TIME ON/OFF pad.ONIOFFOven Temperature KnobThe oven temperature knob maintains the temperatureyou set from WARM ( 170°F.) to BROIL (550”F.).It also has an OFF and an AUTO CLEAN setting.The PREHEATED light glows when the ovenreaches your selected temperature.The OVEN ON light will glow any time the OvenTemperature knob is not in the OFF position and isset on a temperature or a function.-2 /1”1 \ Y’””\ ~ A-”-(appearance may vary)USING YOUR OVENOven ShelvesWhen placing cookware on a shelf. pull the shelf outto the bump on the shelf support. Place the cookwareon the shelf, then slide the shelf back into the oven.This will eliminate reaching into the hot oven.To remove the shelves from the oven, pull towardplJ%!%~:<~! -.you, tilt the front end upward and pull them out. :=<——–. --———_—To replace, place the shelf on the shelf support with ~“=-~”-k~ //the stop-locks (curved extension under the shelf) ~~Ifacing up toward the rear of the oven. Tilt up the front The shelves are designed with stop-locks so thatand push the shelf toward the back of the oven until it when placed correctly on the shelf supports, theygoes past the bump on the shelf support. Then lowerthe front of the shelf and push it all the way back. will stop before coming out completely from theoven, and will not tilt when removing food from or12 placing food on them.