GE JCK 915 Owner's Manual

Also see for JCK 915: Manual Technical service guide

GE JCK 915 Owner's Manual Manual pdf 24 page image

Safety InstructionsOperating InstructionsCare and CleaningTroubleshooting TipsConsumer SupportCare and cleaning of the oven.Press down and pull out.Removable Oven FloorTo remove the oven floor:Remove the oven door using theinstructions in the Lift-Off Oven Doorsection of this manual.Press down and pull out theremovable oven floor.Clean the oven floor with warmsoapy water.When reinstalling the oven floor, besure to slide it all the way to the backof the oven.IMPORTANT: Always replace theremovable floor before the next use.The gasket is designed with a gap at thebottom to allow for proper air circulation.Do not rub or clean the door gasket—it has an extremely low resistance toabrasion.If you notice the gasket becoming worn,frayed or damaged in any way or if it hasbecome displaced on the door, you shouldhave it replaced.To clean the inside of the door: Because the area inside the gasket iscleaned during the self-clean cycle, youdo not need to clean this by hand. The area outside the gasket andthe door liner can be cleaned with asoap-filled steel-wool or plastic pad,hot water and detergent. Rinse wellwith a vinegar and water solution.To clean the outside of the door: Use soap and water to thoroughlyclean the top, sides and front of theoven door. Rinse well. You may alsouse a glass cleaner to clean the glasson the outside of the door. Do not letwater drip into the vent openings. If any stain on the door vent trim ispersistent, use a soft abrasive cleanerand a sponge-scrubber for best results. Spillage of marinades, fruit juices,tomato sauces and basting materialscontaining acids may causediscoloration and should be wipedup immediately. When surface is cool,clean and rinse. Do not use oven cleaners, cleaningpowders or harsh abrasives on theoutside of the door.Cleaning the Oven Door24The door is very heavy. Be careful whenremoving and lifting the door.Do not lift the door by the handle.To remove the door:Fully open the door.Pull the hinge locks down towardthe door frame, to the unlockedposition. A tool, such as a smallflat-blade screwdriver, may berequired.Firmly grasp both sides of the doorat the top.Close door to the door removalposition, which is halfway betweenthe broil stop position and fullyclosed.Lift door up and out until the hingearm is clear of the slot.To replace the door:Firmly grasp both sides of the doorat the top.With thedoor at thesame angle asthe removalposition, seat theindentation ofthe hinge arminto the bottomedge of the hingeslot. The notch in the hinge armmust be fully seated into the bottomof the slot.Fully open the door. If the door willnot fully open, the indentation isnot seated correctly in the bottomedge of the slot.Push the hinge locks up against thefront frame of the oven cavity, to thelocked position.Close the oven door.Hinge lockLift-Off Oven DoorRemoval positionIndentationBottomedgeof slotHinge lockSlotPush hinge locks up to lock.Pull hinge locks down to unlock.Hinge armHingearm