GE JD900 Owner's Manual

Also see for JD900: Installation instructions Installation instructions Owner's manual Owner's manual Owner's manual

GE JD900 Owner's Manual Manual pdf 22 page image

Control Panel Clean up splatters with a damp cloth. You may also use a glass cleaner. Remove heavier soil with warmsoapy water. Do not use abrasives of any kind.Painted SurfacesPainted surfaces include the door, top ofthe control panel and the drawer front.Clean these with soap and water or avinegar and water solution.Do not use commercial oven cleaners,cleaning powders, steel wool or harshabrasives on any painted surface.22Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety InstructionsCare and cleaning of the range.Do not rub or clean the door gasket—it has an extremely low resistance toabrasion.If you notice the gasket becoming worn,frayed or damaged in any way or if it hasbecome displaced on the door, you shouldhave it replaced.To clean the inside of the door: Because the area inside the gasket iscleaned during the self-clean cycle, youdo not need to clean this by hand. The area outside the gasket andthe door liner can be cleaned with asoap-filled steel wool or plastic pad,hot water and detergent. Rinse wellwith a vinegar and water solution.To clean the outside of the door: Use soap and water to thoroughlyclean the top, sides and front of theoven door. Rinse well. You may alsouse a glass cleaner to clean the glasson the outside of the door. Do not letwater drip into the vent openings. If any stain on the door vent trim ispersistent, use a soft abrasive cleanerand a sponge-scrubber for best results. Spillage of marinades, fruit juices,tomato sauces and basting materialscontaining acids may causediscoloration and should be wipedup immediately. When surface is cool,clean and rinse. Do not use oven cleaners, cleaningpowders or harsh abrasives on theoutside of the door.Cleaning the Oven DoorThe door is very heavy. Be careful whenremoving and lifting the door.To remove the door:Fully open the door.Pull the hinge locks down towardthe door frame, to the unlockedposition. A tool, such as a smallflat-blade screwdriver, may berequired.Firmly grasp both sides of the doorat the top. Do not lift the door by thehandle.Close door to the door removalposition, which is halfway betweenthe broil stop position and fullyclosed.Lift door up and out until the hingearm is clear of the slot.To replace the door:Firmly grasp both sides of the doorat the top. Do not lift the door by thehandle.With thedoor at thesame angle asthe removalposition, seat thenotch stop ofthe hinge arminto the bottomedge of the hinge slot. The notch inthe hinge arm must be fully seatedinto the bottom of the slot.Fully open the door until it isparallel to the floor. If the door willnot fully open, the notch stop is notseated correctly in the bottom edgeof the slot. Repeat step 2 ifnecessary.Push the hinge locks up against thefront frame of the oven cavity to thelocked position.Close the oven door.Lift-Off Oven DoorHinge lockRemoval positionNotch stopBottomedgeof slotHinge lockSlotPush hinge locks up to lock.Pull hinge locks down to unlock.Hinge armHingearm