29Control PanelIf desired, the touch pads may be deactivatedbefore cleaning.See the Cooking/Self-Clean lockoutinformation in the Special features ofyour oven control section in this manual.Clean up splatters with a damp cloth.You may also use a glass cleaner.Remove heavier soil with warm soapywater. Do not use abrasives of any kind.Reactivate the touch pads after cleaning.Care and cleaning of the range. ge.comBe sure all controls are off and all surfaces are cool before cleaning any part of the range.Control KnobsThe control knobs may be removed for easiercleaning.Before removing the knobs forcleaning, please note that the knobs arein the OFF position. When replacing theknobs, check the OFF position to insureproper placement.Wash the knobs in soap and water or avinegar and hot water solution but donot soak.If your range is removed for cleaning, servicing or any reason, be sure the anti-tipdevice is reengaged properly when the range is replaced. Failure to take thisprecaution could result in tipping of the range and cause injury.Oven VentThe oven vent is above the left side of the door.This area could become hot duringoven use.It is normal for steam to come out ofthe vent.The vent is important for proper air circulation.Never block this vent.Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportHow to Remove Protective Shipping Film and Packaging TapeCarefully grasp a corner of the protectiveshipping film with your fingers and slowlypeel it from the appliance surface. Do notuse any sharp items to remove the film.Remove all of the film before using theappliance for the first time.To assure no damage is done to thefinish of the product, the safest way toremove the adhesive from packaging tapeon new appliances is an application of ahousehold liquid dishwashing detergent.Apply with a soft cloth and allow to soak.NOTE: The adhesive must be removed from allparts. It cannot be removed if it is baked on.