GE JGP326 Owner's Manual
Also see for JGP326: Owner's manualOwner's manualInstallation instructionsInstallation instructions
                                | |
9Care and cleaning of the cooktop. GEAppliances.comBe sure electrical power is off and all surfaces are cool before cleaning any part of the cooktop.How to Remove Packaging TapeTo assure no damage is done to the finishof the product, the safest way to removethe adhesive left from packaging tape onnew appliances is an application of ahousehold liquid dishwashing detergent,mineral oil or cooking oil.Apply with a soft cloth and allow to soak.Wipe dry and then apply an appliancepolish to thoroughly clean and protectthe surface.NOTE: The plastic tape must be removed from allchrome trim. It cannot be removed if it is baked on.Control KnobsClean up spatters with a damp cloth.Remove heavier soil with warm, soapywater.Do not use abrasives of any kind on the controlpanel.The control knobs may be removed foreasier cleaning. To remove a knob, pull itstraight off the stem. Wash the knobs insoap and water but do not soak.Pull the knob straight off the stem.Burner AssemblyThe burner assemblies should be washedregularly and, of course, after spillovers.Turn all controls off before removing burner parts.The burner grates, burner heads andburner caps can be removed for easycleaning. Removing them gives youaccess to the burner bowls.The electrode of the spark igniter isexposed beyond the surface of theburner bowl. When cleaning the burnerbowl, be careful not to snag the electrodeof the spark igniter with your cleaningcloth. Damage to the igniter could occur.To avoid snagging a cloth on the sparkigniter, leave the burner heads in placewhen cleaning the burner bowls.Be careful not to push in any cooktopcontrols while cleaning the burner bowls.A slight electrical shock might resultwhich could cause you to knock over hotcookware.Wash burner parts with an all-purposenon-abrasive cleaner and warm water.Soak stubborn soil. Dry them with acloth—do not reassemble while wet.If the igniter orifice gets dirty or cloggedyou may use a small sewing needle toremove the soil.To reassemble, replace the burner headfirst, then the burner cap and finally theburner grate.CAUTION: DO NOT OPERATE THEBURNER WITHOUT ALL BURNERPARTS IN PLACE.GrateBurner capBurner headSpark igniterMixing tubeBurner bowlSafety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support |
Related manuals for GE JGP326
manualsdatabase
Your AI-powered manual search engine