GE JP383 Use And Care & Installation Manual

Contents

QUES~ONS?USE THIS PROBLEM SOLVERPROBLEMFOODS S~CK ‘ “’”TO G~OR :“ ‘:G~D~ :,,: ..:, . . ,,,,. ,.POSS~LE CAUSE*, Dfi,&& ~y ~ in the main distribution ‘~el tifyow’house -by a,,b]OW.&@~t~, a tri~bitbreaker, the main& or@e.main@dtbreaker,’ depending on nature of the power kupply. Ha titiit breaker is‘tivOk@zeset i~ tithe mntrol box=-, tie Amif tie (a ~dge-w).. shodd be changed. BUT ONLY BY SOMEONE F-R_E~~CAL C~CU~. H, after performing 1 of these prbe$the @ blows or circuit breaker trips agafi dl for servim..NO~:’’_efittenants ormndominim owners shodd requesttheir. . b@ding ~agement to perform this chtik before dtig for seMm.0 Coi&ols are riot ~perlyset or wrong mntrOl is set for the modde or elementyou are using.l ~tire titi unit rnodtie is not plugged’ in properly. ~~• :‘~ E My modde faik to heat-switch the modde to the other side of mktop.Eitoperateson that side, then switch maybe at fati~ ~itdoesnothea~indimtions are that there is a malhdoning mmponent in the modde.l Surfa= units are not plugg~ in sofidy.l Refltior pans are not set -ely in the ~ktop.: S* tit .mntrok tie not properly set or wrong *tit mntrol set‘ forunit youare using..l H~ting element is not plugged in solidy. .—. ;&l or Hae heating element mntrok are not properly =L* To’ use entire da of @l or gri~q it .is nwssary to - on front and~êÜ‹ rear ds tit mntrol set for unit you are using.* GriMe was not pre-seaso ned before first W.l HA Qtig is too high.“ dating of grime has been damaged by = of sharp.instruments orabmive cleane= .. Some smoke, and odor is normrd when using solid disk surf- dts for the first.’ time andk afterwing b~o El~ol@ cleaner.. ~~~,.hotter than you are usedto. This isno~:. -. .+ tiem flat-bottomed pans-M&l Using the vent @ help keep the mktop mler.+ *lutely *t pans must be + Hlight m be seen between the.panbottom and a straightedge, the solid disk and radiant surfam unitswfi notoperate properly. . .—40