GE JRP20 Owner's Manual

Also see for JRP20: Installation instructions Owner's manual Owner's manual Owner's manual Owner's manual

Contents

GE JRP20 Owner's Manual Manual pdf 21 page image

Oven Light Bulb (on some models)NOTE: The glass cover (on some models) shouldbe removed only when cold. Wearing latex glovesmay offer a better grip.Before replacing the bulb, disconnectelectrical power to the oven at the mainfuse or circuit breaker panel. Let thebulb cool completely before removing it.For your safety, do not touch a hot bulbwith a damp cloth. If you do, the bulbwill break.To remove:Turn the glass cover counterclockwise1/4 turn until the tabs of the glass coverclear the grooves of the socket. Removethe bulb.To replace:Put in a new 40-watt appliance bulb.Place the tabs of the glass cover into thegrooves of the socket. Turn the glasscover clockwise 1/4 turn.NOTE: A 40-watt appliance bulb is smaller than astandard 40-watt household bulb. Install and tighten the cover clockwise. Reconnect electrical power to the oven. For improved lighting inside the oven, cleanthe glass cover frequently using a wet cloth.This should be done when the oven iscompletely cool.BulbSocketTabMaximumlength31⁄2”Glass coverWire cover holderOven Light Bulb (on some models)CAUTION: Before replacing your oven light bulb,disconnect the electrical power to the oven at themain fuse or circuit breaker panel.Be sure to let the light cover and bulbcool completely.To remove the cover:Hold a hand under the cover so itdoesn’t fall when released. Withfingers of the same hand, firmlypush back the wire cover holder.Lift off the cover.Do not remove any screws to remove the cover.Replace bulb with a 40-wattappliance bulb.To replace the cover:Place it into grooves of the lightreceptacle. Pull wire forward tothe center of the cover until itsnaps into place.Connect electrical power tothe oven.21Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Supportwww.GEAppliances.comDo not use a steel-wool pad; it will scratchthe surface.To clean the stainless-steel surface, usea hot, damp cloth with a mild detergentsuitable for stainless-steel surfaces. Usea clean, hot, damp cloth to removesoap. Dry with a dry, clean cloth.If food soil remains, try a generalkitchen cleaner, such as Fantastik®,Simple Green®, or Formula 409®.For hard-to-clean soil, use a standardstainless-steel cleaner, such as Bon-Ami®or Cameo®.Apply cleaner with a damp sponge.Use a clean, hot, damp cloth to removecleaner. Dry with a dry, clean cloth.Always scrub lightly in the direction ofthe grain.After cleaning, use a stainless-steelpolish, such as Stainless Steel Magic®,Revere Copper and Stainless SteelCleaner®, or Wenol All Purpose MetalPolish®. Follow the product instructionsfor cleaning the stainless-steel surface.Stainless Steel Surfaces (on some models)