Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportUsing the clock, timer and control lockout. ge.comTo Set the ClockThe clock must be set to the correct timeof day for the automatic oven timingfunctions to work properly. The time ofday cannot be changed during a timedbaking or self-cleaning cycle.Press the CLOCK pad.Press the number pads.Press the START pad.Make sure the clock is set to thecorrect time of day.To Set the TimerPress the KITCHEN TIMER ON/OFFpad.Press the number pads until theamount of time you want shows inthe display. For example, to set 2hours and 45 minutes, press 2, 4and 5 in that order.If you make a mistake press theKITCHEN TIMER ON/OFF pad andbegin again.Press the START pad.After pressing the START pad, SET disappears;this tells you the time is counting down, althoughthe display does not change until one minute haspassed. Seconds will not be shown in the displayuntil the last minute is counting down.When the timer reaches :00, thecontrol will beep 3 times followedby one beep every 6 seconds untilthe KITCHEN TIMER ON/OFF padis pressed.The 6-second tone can be canceled by followingthe steps in the Special features of your ovencontrol section under Tones at the End of aTimed Cycle.The timer is a minute timer only.The timer does not control ovenoperations. The maximum setting onthe timer is 9 hours and 59 minutes.To Reset the TimerIf the display is still showing the timeremaining, you may change it by pressingthe KITCHEN TIMER ON/OFF pad, thenpress the number pads until the time youwant appears in the display.If the remaining time is not in the display(clock, delay start or cooking time are inthe display), recall the remaining time bypressing the KITCHEN TIMER ON/OFF padand then pressing the number pads toenter the new time you want.To Cancel the TimerPress the KITCHEN TIMER ON/OFF padtwice.Your control will allow you to lock out the presspads so they cannot be activated when pressed.To lock/unlock the controls:Press the 9 and 0 pads at the sametime for 3 seconds, until the displayshows LOC ON.To unlock the control, press the9 and 0 pads at the same time for3 seconds, until the display showsLOC OFF.When this feature is on and the presspads are pressed, the control will beepand the display will show LOC ON. The control lockout mode affects all presspads. No press pads will work when thisfeature is activated. The adjustment will be retained in memoryafter a power failure.Control Lockout13