GE JVM1530DM Owner's Manual

Also see for JVM1530DM: Dimensions and installation information

If Something Goes WrongBefore You Call For ServiceOven will notstartFloor of the oven iswarm, even whenthe oven has notbeen used“LOC” appearson displayVent fan will notturn off“BAD PROBE”appears on display“PLEASE INSERTPROBE“ appearson display“SENSOR ERROR”appears on displayProblem Possible Cause What to DoA fuse in your home • Replace fuse or reset circuit breaker.may be blown or thecircuit breaker tripped.Power surge. • Unplug the microwave oven, then plugit back in.Plug not fully inserted • Make sure the 3-prong plug on theinto wall outlet. oven is fully inserted into wall outlet.Door not securely closed. • Open the door and close securely.The cooktop light is • This is normal.located below the ovenfloor. When the lightis on, the heat itproduces may make theoven floor get warm.The control has been • Press and hold CLEAR/OFF forlocked. about 3 seconds to unlock the control.The vent fan • The vent fan cannot be turned offautomatically turns on while the microwave is operating.to cool internal parts This is normal. Wait for the microwavewhile the microwave to turn off and the fan will either gois on. off automatically or you will need toturn it off by pressing the Vent Fanpad after the microwave is off.The probe has not been • Insert the probe properly into thecompletely inserted into oven wall outlet.the oven wall outlet.The probe is defective. • Replace the probe.Probe has been • Insert the probe properly into theforgotten or not oven wall outlet.inserted properly.When using a Sensor • Do not open door until steam isfeature, the door was sensed and time is shown countingopened before steam down on display.could be detected.Steam was not detected • Use Time Cook to heat for more time.in maximum amountof time.36