GE JVM1540MP2SA Installation Instructions Manual

Contents

GE JVM1540MP2SA Installation Instructions Manual Manual pdf 13 page image

Installation InstructionsUSE TOP CABINETTEMPLATEFOR PREPARATION OF TOPCABINETYou need to drill holes for tile top support screws, ahole large enough for tile power cord to fit through,and a cutout large enough for tile exhaust adaptor.%• Read tile insuuctions on tile TOP CABINETTEMPI ,ATE.• Tape it tmderneath tile top cabinet.• Drill tile holes, following tile instructions on tileTOP (;ABINET TEMPI,ATE.CAUTION: Wear safety goggleswhen drilling holes in the cabinet bottom.CHECK FOR PROPERDAMPER OPERATIONDamperBlowerP_e _. ExhaustAdaptor.... NI_Microwave...-_ . . Oven• Place tile microwave in its upright position, with tiletop of tile unit facing up.• Make sure tape securing damper is removed anddamper pivots easily before mounting microwave.• Slide tile damper into place. Make sure it catchesin tile retaining hooks to secure.• You will need to make adjustments to assure properalignment with your house exhaust duct after tilemicrowave is installed.MOUNTTHE MICROWAVEOVENCAUTION: FoREnSIERINSTALLATION AND PERSONAL SAFETY, WERECOMMEND THAT TWO PEOPLE INSTAI_J_THIS MICROWAVE OVEN.IMPORTANT: Do not grip or use handleduring installation.NOTE: If your cabinet is metal, use tile nylongrommet around tile power cord hole to preventcutting of tile cord.NOTE: We recommend using fillet blocks if thecabinet flont hangs below tile cabinet bottom sheh c.IMPORTANT: If filler blocks arenot used, case damage may occur fromovertightening screws.NOTE: When mountingtile illiciox, vave oven,thread power cordthrough hole in bottom oftop cabinet. Keep it tightthroughout Steps 1-3. Donot pinch cord or liftoven by pulling_!_ IAft tilt itmicrowave,forward, and hookslots at back bottomedge onto four lowerrobs of mounting_ Rotate fiont of ovenup against cabinetbottom._Insert a self-aligning screw through top centercabinet hole. Temporarily secure the oven byturning tile screw at least two full turns after tilethreads have engaged. (It will be completelytightened later.) Be sure to keep power cordtight. Be careful not to pinch the cord, especiallywhen mounting flush to bottom of cabinet.13