GE KTD-400 User Manual

KTD-400 Controller KeypadUser Manual6KTD-400 configurationAfter you install and power up your KTD-400 keypad, you will need to configure it to operate within yoursystems. You can also use the KTD-400 to configure other components in the Digiplex system. (See Systemcomponent configuration on page 10.)The KTD-400 offers many programming choices that identify how it will function in the system. A separatecode is used to access the menus. For new installations, follow the programming steps in the order they arepresented. If you need to change any programmed data at a later date, enter the appropriate programmingmode and use the designated keys to advance the menu associated with that data.• System size (see Figure 11 on page 7)• Camera site access (see Figure 12 on page 7)• Monitor access (see Figure 13 on page 8)• Multiplexer enable and select (see Figure 14 on page 8)• Multiplexer view display (see Figure 15 on page 8)• VCR enabled (see Figure 16 on page 9)• Maximum presets (see Figure 17 on page 9)• Monitor offset (see Figure 18 on page 9)When you supply power to the unit, the LCD will momentarily display a limited amount of configurationinformation on the unit (Figure 7).Figure 7. Programming displayAfter a few seconds, the normal operating display menu (Figure 8 on page 6) will appear.To configure the KTD-400, do the following:.1. In the normal operating display (Figure 8),enter programming mode by pressing andholding the Set key until you see the displayin Figure 9.Figure 8. Normal operating display2. At the code entry display (Figure 9), enterthe access code 5, 7, 9, Seq. Figure 9. Code entry displayLargest Largest Largest Largest Monitor Keycamera monitor multiplexer VCR offset layoutRevision numberKTD-400 DDMMYY255 64 64 64 00 0CAMERA 000MONITOR 01CAMERA 000 (CODE)MONITOR 01 (----)