GE KTD-400 User Manual

9In some applications, you may prefer to number the monitors 1, 2, 3, etc., instead of using the matrix switcheroutput number. To allow for the difference in numbers, subtract the desired monitor number from the matrixswitch output number and enter the result as the monitor offset in the menu shown in Figure 18.For example, if a keypad has a monitor that is connected to matrix switcher output 8, to enable the monitor tobe addressed as monitor 1, subtract 1 from 8 and enter 7 as the monitor offset.8 (matrix switcher number) - 1 (monitor number) = 7 (offset)In this example, if more than one monitor were to be controlled from the keypad, additional monitors would beconnected to matrix switcher outputs 9, 10, 11, etc. and would be controlled as monitors 2, 3, 4, etc.Note: The keypad will deny any monitor offset number that conflicts with the largest monitor (Figure 11 on page 7) andmonitor access (Figure 13 on page 8) programming choices that you made earlier in this section.After you make an entry in the monitor offset display, the keypad will return to the normal operating display.9. The menu in Figure 16 lets you select whichVCRs can be can be enabled from thekeypad. This display will only come up ifyour system has at least one VCR.• If you don’t want to enable any VCRs,press Seq to advance to the maximumpreset display (Figure 17).• Press 0 to advance to the next VCR, oruse the up and down arrows to movebetween VCRs.• Press 1 to enable a VCR. After settingvalues for all VCRs in your system,press Seq to advance to the next menu.Figure 16. VCR access display10. The menu in Figure 17 determines themaximum number of programmable presetsthat can be accessed from the keypad. Therange is from 00 (none) to 63. Press Seq toadvance to the next menu.Figure 17. Maximum preset display11. The default program for the keypad indicatesthat the selected monitor number willcorrespond to the number of the matrixswitcher output to which it is connected. Forexample, if monitor 12 appears in thekeypad’s display window and a cameraselection is made, the monitor that isconnected to output 12 of the matrix switcherwill switch to that camera.Figure 18. Monitor offset displayVCR 01 ACC=YES0=NO 1=YES SEQ=NEXTMAX PRESET: 09(OO FOR NONE) SEQ=NEXTMONITOR OFFSETNUMBER? SEQ=NEXT