Signal Name Source Module Destination Module DescriptionTMEM3Ph 1-pole / 3-pole Trip (13) 3-phase AR Cycle Selection (21) Signal to remember that Autoreclose wasinitiated by a 3-phase faultTMEMANY 1-pole / 3-pole Trip (13) Evolving Fault (20)3-phase AR Cycle Selection (21)Signal to remember that Autoreclose wasinitiated by an AnyTrip4.3 AUTORECLOSE DDB SIGNALSThe following table lists all the DDB signals used in the CB control and Autoreclose logic system:DDB SignalNameDDB SignalNumber Source Module Destination Module1P DTime 1554 1-phase AR Dead Time (24) Sequence Counter (18)Evolving Fault (20)1P Reclaim TComp 1568 Reclaim Time (35) Successful AR Signals1P Reclaim Time 1567 Reclaim Time (35) Reclaim Time Logic2/3 Ph Fault 527 CB Trip Conversion (63)3 Ph Fault 528 CB Trip Conversion (63)3P Dead Time IP 853 3-phase AR Dead Time (25)3P Dtime 1560 3-phase AR Dead Time (25)3P DTime1 1556 3-phase AR Dead Time (25)3P DTime2 1557 3-phase AR Dead Time (25)3P DTime3 1558 3-phase AR Dead Time (25)3P DTime4 1559 3-phase AR Dead Time (25)3P Reclaim TComp 1570 Reclaim Time (35) Successful AR Signals3P Reclaim Time 1569 Reclaim Time (35) Reclaim Time LogicA/R CB Unhealthy 307 CB Healthy and System Check Timers (39) Force 3-phase TripAutoreclose LockoutA/R Lockout 306 Autoreclose Lockout (55)CB In ServiceAR OKForce 3-phase TripEvolving FaultCB Autoclose LogicCB Healthy and System Check Timers LogicAR Shot CountersReset CB LockoutPole DiscrepancyA/R No Checksync 308 CB Healthy and System Check Timers (39) Autoreclose LockoutAny Trip 522 CB Trip Conversion (63)AR InitiationCB Autoclose LogicCB ControlAR 1pole in prog 8451-phase AR Cycle SelectionDead Time Start EnablePole DiscrepancyAR 3pole in prog 844 3-phase AR Cycle SelectionAR Enable 1384 AR EnableAR Enable CB 1609AR EnableAR OKAR Modes EnableP543i/P545i Chapter 11 - AutorecloseP54x1i-TM-EN-1 311
