GE Monogram ZV30H Owner's Manual

Also see for Monogram ZV30H: Owner's manual Installation instructions Installation instructions

Contents

The drip tray should be cleaned once a month oras needed.To remove the drip tray, first remove the bafflegrease filters. Grasp both ends of the drip tray.Gently lift the drip tray up until the bottom of itclears the track. Pull the drip tray forward, beingcareful not to spill the contents, and move it to anearby trash receptacle.To clean the drip tray, drain and wipe all excessgrease with a dry paper towel. Wash with warmsoapy water or in the dishwasher. Dry with aclean cloth.To replace the drip tray, lift it up and into thetrack on the hood. Replace baffle grease filters.Care and CleaningStainless Steel Hood7Drip trayDrip trayLight bulbs nOte: The glass cover should be removed only when cool.CautIOn:Before replacing the bulb, disconnect electricalpower to the hood at the main fuse or circuitbreaker or main power disconnect switch locatedon the control housing. Allow bulbs to cool beforetouching.For safety, do not touch a hot bulb with bare handsor a damp cloth.to change the light bulbs:1. Remove the lamp lens cover by inserting a smallflat-blade screwdriver into each of the three slotsand gently prying it free.nOte: Do not remove the outer trim ring (lampassembly).2. Grasp the bulb and pull it straight out.3. Using gloves or a dry cloth, remove the new bulbfrom the packaging. (Wearing latex gloves may offera better grip.) The bulb must be the same wattage,120-volt, 25-watt halogen with a G-9 base. Early-lifebulb failure may occur if wattage is too high.4. Push the bulb straight all the way into thereceptacle.5. Replace the lens cover by inserting the threeretaining tabs into the slots and pressing into place.nOte: For improved lighting, clean the glass coverfrequently using a damp cloth. This should be donewhen the hood is completely cool.6. Reconnect electrical power to the hood.nOte: Order replacement 120-volt, 25-watthalogen bulb with G-9 base, WB25x10020.These bulbs can be ordered from GE parts. Please seeConsumer Services page in the back of this manual.Use a small flat-blade screwdriverto remove the lamp lens cover.Outer trim ring(lamp assembly)Do not removeBulbRemovable innerlamp lens covernOte: Make sure the tabs areinserted into the slots.TabOnLy use a new 120-volt, 25-watthalogen bulb with a G-9 base.ReceptacleUse glovesor clothnOte: Do not touch the new halogen bulbwith bare fingers. Skin oils can cause early-life bulb failure.