GE PEB2060SMSS Installation Instructions Manual

Also see for JX2027: Installation instructions Installation instructions

Contents

GE PEB2060SMSS Installation Instructions Manual Manual pdf 2 page image

❒ CUTOUT DIMENSIONS12* Min. depth with receptacle outside cabinet 191⁄ 2″Min. depth with receptacle inside cabinet 22″120 volt-60 Hertz grounded power receptacleInstallation InstructionsModels 27″ 30″Height 16 3⁄ 4″ 163⁄ 4″Width 251⁄ 2″ 251⁄ 2″Depth (min.)* 191⁄ 2″ or 22″ 191⁄ 2″ or 22″WARNING — This trim kit uses air flowfrom the top, bottom and sides of the trim frame.Blocking the air flow can cause the microwave tofunction improperly and may cause damage tothe microwave.Allow a 1″ clearance beyond the edge of the trimframe to provide proper air flow.On 27″ models, allow 11⁄ 8″ at the top, 11 ⁄ 16″ on the sidesand 1 1⁄ 4″ at the bottom for overlap of the Trim Frameover the edges of the cutout.On 30″ models, allow 11⁄ 8″ at the top, 2 1⁄ 16″ on the sidesand 1 1⁄ 4″ at the bottom for overlap of the Trim Frameover the edges of the cutout.FOR INSTALLATION ABOVE ABUILT-IN OVEN:Microwave oven should be installed on a 3/8″ plywoodbase and supported by 2x4 or 1x2 equivalent runnerson all sides. Base must be capable of supporting aminimum of 100 lbs (45.3 kg).Draw a line on the cutout floor at the center of thecutout, and extend the line 1/2″ down the face ofthe cabinet.Draw a line on the top front face of the cabinetat the center of the cutout. The line should extend1/2″ up the face of the cabinet. This center line willbe used for mounting the top bracket (see step 7).Fold or cut the front edge of the template, along thefront guide line. Place the template flush along thefront edge of the cutout floor, aligning the center lineof the template with the center line of the cutoutfloor. Mark the center positions with an awl or centerpunch for the anti-tip brace location as shown.Drill two holes for the anti-tip brace.Install the anti-tip brace onto the cutout floor usingtwo round-head screws.BCDEDDRound-headscrews (2)Anti-Tip Brace❒ INSTALL THE ANTI-TIP BRACE2DepthHeight11⁄ 4″ OverlapWidth11⁄ 8″ Overlap1″ Clearancebeyond trim frame(on all sides)3″ Min.27″ Models: 11⁄ 16″ overlap30″ Models: 21⁄ 16″ overlapADIMENSIONS:A = 11⁄ 2″B = 3″C = 18 3⁄ 16″D = 1/2″Bottom of trim kitmust be minimumof 36″ from floor1′ = 0.3 m1″ = 2.5 cm