GE PGS968SEMSS Owner's Manual

Also see for Profile JGS968 SERIES: Dimensions and installation information Technical service guide Installation instructions Owner's manual Installation instructions

GE PGS968SEMSS Owner's Manual Manual pdf 31 page image

31Be sure all controls are off and all surfaces are cool before cleaning any part of the range.Control KnobsThe control knobs may be removed for easiercleaning.Make sure the knobs are in the OFFpositions and pull them straight off thestems for cleaning.The knobs can be cleaned in adishwasher or they may also be washedwith soap and water. Make sure the insidesof the knobs are dry before replacing.Replace the knobs in the OFF positionto ensure proper placement.If your range is removed for cleaning, servicing or any reason, be sure the anti-tipdevice is reengaged properly when the range is replaced. Failure to take thisprecaution could result in tipping of the range and cause injury.Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportBurner AssemblyThe burner assemblies should be washedregularly and, of course, after spillovers.Turn all controls off before removing burner parts.The burner grates, burner heads andburner caps can be removed for easycleaning.The electrode of the spark igniter isexposed beyond the surface of theburner base. When cleaning the cooktop,be careful not to snag the electrode ofthe spark igniter with your cleaningcloth. Damage to the igniter could occur.To avoid snagging a cloth on the sparkigniter, leave the burner heads in placewhen cleaning the cooktop.Be careful not to push in any cooktopcontrols while cleaning the cooktop.A slight electrical shock might resultwhich could cause you to knock overhot cookware.Wash burner parts with an all-purposenon-abrasive cleaner and warm water.Soak stubborn soil. Dry them with acloth—do not reassemble while wet.To reassemble, replace the burner headfirst, then the burner cap and finally theburner grate. Be sure the pins in theburner head are properly located in theburner base holes.CAUTION: DO NOT OPERATE THEBURNER WITHOUT ALL BURNERPARTS IN PLACE.ElectrodeBurner capBurner headBurner baseGrateHow to Remove Protective Shipping Film and Packaging TapeCarefully grasp a corner of the protectiveshipping film with your fingers and slowlypeel it from the appliance surface. Donot use any sharp items to remove thefilm. Remove all of the film before usingthe appliance for the first time.To assure no damage is done to thefinish of the product, the safest way toremove the adhesive from packaging tapeon new appliances is an application of ahousehold liquid dishwashing detergent.Apply with a soft cloth and allow to soak.NOTE: The adhesive must be removed from allparts. It cannot be removed if it is baked on.ge.com (U.S.)Care and cleaning of the range. www.GEAppliances.ca (Canada)