GE PSC21MGM Technical Service Manual

Contents

– 25 –6. With 2 small flat-blade screwdrivers, unlockthe ice crusher locking tabs located at eitherside of the ice crusher.7. Lift the ice crusher out of the bucket.8. Remove the ice crusher back cover.9. Remove the locking ring from the ice crusherauger.10. Remove the plastic nut with a pair of pliers byturning it clockwise.11. Remove the spacers and blades. The bladesare numbered for reassembly.Ice Dispenser Auger Drive and CubeSolenoidThe ice dispenser drive motor and cube solenoidare located in the upper rear of the freezercompartment. The drive motor moves the augervia a fork located on the drive motor. The cubesolenoid allows cube or crushed ice to bedispensed on demand.1. Remove 1/4-in. housing mounting screws (4)located at the four corners of the housing.2. Slide the housing forward until the connector isvisible, disconnect the connector, and removethe unit from the housing.GEA00952ScrewsScrewsNote: Drive fork has reverse threads; turnclockwise to remove.3. Remove the fork from the drive motor byturning it clockwise.4. Disconnect the motor connectors and removethe ground wire.5. Remove 1/4-in. mounting screws (3) andremove the motor.6. Disconnect the cube solenoid wires.7. Remove cube solenoid 1/4-in. mountingscrews (2) and remove the cube solenoid.IcemakerThe icemaker is located in the upper rear of thefreezer compartment and supplies ice to thedispenser tub.1. Disconnect the icemaker cable connector.2. Remove 1/4-in. icemaker mounting screwsand slide out the icemaker.This refrigerator is equipped with an ElectronicIcemaker. Refer to Pub # 31-9063 for moreinformation.