GE PSXH47 Installation Instructions Manual

Also see for PSXH47: Owner's manual

Contents

GE PSXH47 Installation Instructions Manual Manual pdf 5 page image

5PACKINGUNPUNPUNPUNPUNPACKINGACKINGACKINGACKINGACKING1. Using the four shipping carton corner posts (two on each side),carefully lay the dryer on its left side and remove the foamshipping base.To prevent damage, do not use the control panelas a means to pick up or move the dryer.2. Return the dryer to an upright position.MOBILE HOME INSTALLATION1. Dryer MUST be exhausted outside (outdoors, not beneath themobile home) using metal ducting that will not supportcombustion. Metal ducting must be 4 inches (10.16 cm) indiameter with no obstructions. Rigid metal duct is preferred.2. If dryer is exhausted through the floor and area beneath themobile home is enclosed, the exhaust system MUSTterminate outside the enclosure with the termination securelyfastened to the mobile home structure.3. When installing a gas dryer into a mobile home, a provisionmust be made for outside make up air. This provision is to benot less than twice the area of the dryer exhaust outlet.4. This dryer MUST be fastened to the floor. Mobile HomeInstallation Kit No. 346764 is available from your dealer.5. Refer to pages 2 and 3 for other important ventingrequirements.6. Installation MUST conform to current Manufactured HomeConstruction & Safety Standard (which is a Federal RegulationTitle 24 CFR-Part 32-80) or when such standard is notapplicable, with American National Standard for MobileHomes.The dryer is designed under ANSI Z 21.5.1 orANSI/UL2158 - CAN/CSA C22.2 (latest editions) for HOME USEonly.FOAMSHIPPINGPADREVERSING DOOR SWINGYour dryer is designed so the door swing may be reversed at anytime without additional parts. Conversion is accomplished bytransferring hinges to the opposite side of the cabinet."Solid door " Reversal Instructions:1. Open the dryer door. Remove the four hinge hole plugs fromthe left side of the door opening. Place nearby for futureinstallation. NOTE: You may need a plastic knife to help pullout the plugs. Be careful not to scratch the paint.2. Remove the four screws that secure the door hinges to thedryer front panel (see below). NOTE: Remove one screw fromeach of the two hinges first. Hold the door firmly beforeremoving the last two screws.3. Rotate the door 180° and reinstall the door hinges to the dryerfront panel with the four screws.4. Install the four hinge hole plugs in the open screw holes on theright side of the door opening.REMOVE 4 SCREWS(ONE FROM EACHHINGE FIRST)