GE PVM9195 Installation Instructions Manual

Also see for PVM9195: Use and care manual Installation instructions Installation instructions Owner's manual Owner's manual

Contents

GE PVM9195 Installation Instructions Manual Manual pdf 19 page image

USE TOP CABINET TEMPLATEFOR PREPARATION OF TOP CABINETC219RECIRCULATING (Non-Vented Ductless)INSTALLATION OVERVIEWC1. Attach Mounting Plate to WallC2. Prepare Top CabinetC3. Adjust BlowerC4. Mount the OvenC5. Install Charcoal Filter (not supplied) Read the instructions on the TOP CABINETTEMPLATE. Tape it underneath the top cabinet. Drill the holes, following the instructions on the TOPCABINET TEMPLATE.CAUTION: Wear safety goggles whendrilling holes in the cabinet bottom.Installation InstructionsYou need to drill holes for the top support screws anda hole large enough for the power cord to fit through.CPlace the mounting plate against the wall and insertthe toggle wings into the holes in the wall to mountthe plate.NOTE: Before tightening toggle bolts and wood screw,make sure the tabs on the mounting plate touch thebottom of the cabinet when pushed flush against thewall and that the plate is properly centered under thecabinet.CAUTION:%HFDUHIXOWRDYRLGSLQFKLQJILQJHUVEHWZHHQWKHEDFNRIWKHPRXQWLQJSODWHDQGthe wall.Tighten all bolts. Pull the plate away from the wallto help tighten the bolts.3ATTACH THE MOUNTING PLATETO THE WALLC1Attach the plate to the wall using toggle bolts. At leastone wood screw must be used to attach the plate toa wall stud.Remove the toggle wings from the bolts.Insert the bolts into the mounting plate throughthe holes designated to go into drywall and reattachthe toggle wings to 3ø4s onto each bolt.14WallMountingPlateSpacing forToggles More ThanWall ThicknessBolt EndToggleBoltToggle WingsTo use toggle bolts:21” = 2.5 cm; 1’ = 0.3 m