GE Profile 165D4700P382 Owner's Manual

Contents

5Consumer SupportTroubleshooting TipsOperating InstructionsSafety InstructionsSPEED CYCLE 7.5 gal. (28.4 l), 35 min.(on some models) This cycle is for everyday dishes and glassware.CHINA CRYSTAL 7.5 gal. (28.4 l), 35 min.or HAND/GENTLE This cycle is for lightly soiled china and crystal.GLASSES 7.5 gal. (28.4 l), 35 min.(on some models) This cycle is specifically designed for glasses.RINSE ONLY 2.5 gal. (9.5 l), 10 min.or RINSE & HOLD For rinsing partial loads that will be washed later. Do not use detergent with this cycle.NOTE: The CHINA CRYSTAL/PLASTICS (some models) selector is a toggle pad; toggle the pad until thedesired cycle is indicated.NOTE: This dishwasher is equipped with a CleanSensor™ with automatic temperature control; therefore, cyclelength and time may vary depending on soil and temperature conditions.NOTE: Only the Anti-Bacteria cycle has been designed to meet the requirements of Section 6, NSF 184 for soilremoval and sanitization efficacy.Enhancements/ExtrasThe light above the selected pad will be ON to indicate which ENHANCEMENT/EXTRA has been selected.PRE WASH For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be(on some models) selected PRIOR to starting the cycle. This option adds 16 minutes to the cycle time.NOTE: Cannot be selected with RINSE ONLY cycle.HEATED DRY When HEATED DRY is off, dishes will air dry.Light OFFHEATED DRY Turns the heater on for faster drying. This will extend the total cycle time betweenLight ON 8 and 38 minutes depending on the cycle selected. NOTE: HEATED DRY cannot beselected with RINSE ONLY cycle.LOCK You can lock the controls to prevent any selections from being made. Or you can lockthe controls after you have started a cycle.Children cannot accidentally start dishwasher by touching pads with this optionselected.To unlock the dishwasher controls, touch and hold the HEATED DRY pad for 3 seconds.The light above the LOCK pad will turn off. To lock the dishwasher, touch and hold theHEATED DRY pad for 3 seconds. The light above the LOCK pad will turn on.ADDED HEAT or When selected, the cycle will run with heating element on longer and mayEXTRA HOT WASH increase cycle times to improve both wash and dry performance.or TEMP BOOST NOTE: Cannot be selected with RINSE ONLY cycle.(on some models)DELAY HOURS You can delay the start of a wash cycle for up to 9 hours. Touch the DELAY HOURS padto choose the number of hours you want to delay the start of the cycle; then touchSTART/RESET. The machine will count down and start automatically at the correct time.Touching START/RESET a second time will cancel the DELAY START selection. NOTE: Ifyou forget to fully close the door, a reminder signal will beep until you do so.RESET To change a cycle after washing starts, touch the START/RESET pad to cancel thecycle. The START/RESET light will flash while the water is pumped out if needed. Thistakes approximately 90 seconds. When the light stops flashing, the dishwashercan be reprogrammed and restarted.ge.com4