GE Profile 165D4700P382 Owner's Manual

Contents

Consumer SupportTroubleshooting TipsOperating InstructionsSafety InstructionsPrior to the first use, the dishwasher needs tobe calibrated for water hardness. Please followdirections below to calibrate the dishwasher tothe hardness of your tap water.Determine the Hardness of Your Tap WaterIn the bag containing these instructions, you shouldfind a water hardness test strip package. Read theinstructions on the package, remove the test strip andfollow the instructions to determine the hardness levelof your tap water. You will use this information tocalibrate your dishwasher to dispense the optimalamount of detergent.Water hardness test strip indicationSet Control to Calibration ModeFrom the standby mode (dishwasher not runninga cycle and the panel lights on), enter the waterhardness selection mode.Control Calibration1. Close and latch the door (lights on, dishwashernot running).2. Press the COOKWARE and DELAY HOURS pads atthe same time for 3 seconds. The display will showa number 1 to 5. This is the water hardness valuecurrently set.3. Press the COOKWARE pad to raise the value orthe NORMAL pad to lower the value. Set the waterhardness value (1 to 5) to the number determinedwith the test strip and table at left.4. Once the water hardness is set, press theSTART/RESET pad to save the setting and returnthe dishwasher to normal operation.You should recalibrate the dispenser if waterconditions change, for example, if a water softenersystem is added or removed.ge.comSmartDispenseTM Detergent DispenserWater Hardness CalibrationControl Panel0 RED1 RED2 RED3 RED4 RED12345SOFTHARDValue to Enterinto Dishwasher9Press at the same time for 3 seconds. DisplayControl PanelPress NORMALWASH pad to lowerthe value.Press COOKWAREpad to raise thevalue.