GE Profile 42 Owner's Manual And Installation Instructions

Also see for Outdoor cooking center 48: Owner's manual Use and care guide Owner's manual Owner's manual Installation instructions

14Replacing the light bulbs.Setting the controls to OFF does not remove power to the light circuit.5HIULJHUDWRU&RPSDUWPHQW³8SSHU/LJKWRaise the grille panel, set the master powerswitch to the O (off) position and allowlamps to cool.To remove the light shield, press onthe sides of the shield and pull down.Replace the bulbs with appliance bulbsof the same or lower wattage. Replace theshield by engaging the bottom tab into theslot and applying light forward pressureuntil the shield snaps in place.Set the master power switch to the I (on)position and close the grille panel.5HIULJHUDWRU&RPSDUWPHQW³/RZHU/LJKWThis light is located above the top drawer.Raise the grille panel, set the master powerswitch to the O (off) positionand allow lamps to cool.Remove items from the shelf abovethe light shield. Remove the shelf.Use both hands to grasp each endof the light shield. Press in on the bottom ofthe shield with your thumbs while rotatingthe cover up and out.Replace the bulb with an appliance bulb ofthe same or lower wattage. Replace theshield by engaging the bottom tab into theslot and applying light forward pressureuntil the shield snaps in place.Set the master power switch to the I (on)position and close the grille panel.Freezer CompartmentRaise the grille panel, set the master powerswitch to the O (off) position and allowlamps to cool.Remove the items from the shelf just belowthe light shield. Remove the shelf.To remove the light shield, press downon the top of the shield and pull the tabsout of the slots. Tilt the shield forward andout.Replace the bulb with an appliancebulb of the same or lower wattage,and reinstall the light shield. Replacethe shield by engaging the bottom tab intothe slot and applying light forward pressureuntil the shield snaps in place.Set the master power switch to the I (on)position and close the grille panel.DispenserRaise the grille panel, set the master powerswitch to the O (off) positionand allow lamps to cool.The bulb is located in the dispenser underthe control panel. Removethe two screws from the light shield.Slide the light shield toward the dispenserto disengage the tabs, then remove thelight shield. Remove the light bulb byturning it counterclockwise.Replace the bulb with a bulbof the same size and wattage. Replacethe light shield by sliding the tabs intothe slots in the front of the dispenser.Replace the two screws.Set the master power switch to the I (on)position and close the grille panel.(appearance may vary)