GE Profile 42 Owner's Manual And Installation Instructions

Also see for Outdoor cooking center 48: Owner's manual Use and care guide Owner's manual Owner's manual Installation instructions

THE INSTALLATION SPACEWater and Electrical LocationsThe opening must be prepared with the electricaland water supply located as shown.The cutout depth must be 24”The refrigerator will project forward, slightlybeyond adjacent cabinets, depending on yourinstallation.Additional Specifications• A 120 volt, 60Hz, 15 or 20 amp power supplyis required. An individual properly groundedbranch circuit or circuit breaker isrecommended. Install a properly grounded3-prong electrical receptacle recessed intothe back wall. Electrical must be located onrear wall as shown.Note: GFI (ground fault interrupter) is notrecommended.• Water line can enter the opening through thefloor or rear wall. The water line installed shouldbe 1/4” O.D. copper tubing or GE SmartConnect™tubing between the cold water line and waterconnection location. The line should be longenough to extend to the front of the refrigerator.Installation of an easily accessible shutoff valvein the water line is required.DIMENSIONS AND CLEARANCESAllow minimum clearances for Freezer door(Dimension A) and Fresh Food door (Dimension B)for a full 130° door swing and to allow for drawerremoval.Four inch (4”) minimum clearance is required whendoor swing is adjusted to 90°. If the 90° door stopposition is used, drawer access is maintained, butdrawer removal is restricted.See illustrations, pages 18 and 19, to determinedoor swing interaction with adjacent cabinets orcountertops.*The finished cutout width must be: 41-1/2”for 42” models and 47-1/2” for 48” models*84" FromFloor toTop Frame**Case Width25-3/8" Case DepthDepth IncludingHandles 26-7/8"*81-3/4"at Rear42" Frame-to-Frame for 42" Models48" Frame-to-Frame for 48" Models*Finished WidthElectricalArea84 1/2" max83 1/2" minFinishedOpening74"From Floorto Bottomof Electrical24"5" 5" 3 1/2"Water Supply3 1/2"3"7"7"Product ClearancesThese refrigerators are equipped with a 2 positiondoor stop. The factory set 130° door swing can beadjusted to 90° if clearance to adjacent cabinetsor walls is restricted.130° Door Swing 90° Door SwingBA23-7/8“BehindFrameCDDModels A B C D42” 12-3/16” 16” 24” 5”48” 13-7/16” 18-9/16” 28” 5”Installation Instructions*Shipping heightThe front heightmay be adjustedfrom 83-1/2” to84-1/2” by adjustingfront and rearleveling legs amaximum of 1”.**The case width must be: 41” for 42”models and 47” for 48” models17