GE SBSD227FWW Installation Instructions Manual

Also see for SBSD227FGG: Installation instructions

KIT CONTENTS4 Support Pads4 Mounting ScrewsDrawer Divider1SBSD227FWWWhite Pedestal BaseTOOLS YOU WILL NEEDPhillips HeadScrewdriver9/16″ Open End Wrenchor Adjustable Wrench8 mm Socket WrenchREMOVE THE LEVELING LEGSCarefully lay the washer or dryer on itsside to access the leveling legs on thebottom of the appliance.IMPORTANT: Do not lay the washer or dryeron its back! Do not remove the shippingbolts on the back side of the washer. Thebolts must remain in place until the washeris returned to an upright position.Use an open-end wrench to remove thewasher or dryer leveling legs.BA1INSTALLATION PREPARATIONRemove the packaging.The Drawer divider is taped at the top of theshipping carton. Remove the divider and setaside for final installation.Flatten the product carton to use as a padto lay the washer or dryer down on its side.Continue using the carton to protect the finishedfloor in front of the installation location.Back out and removeall 4 leveling legsInstructions en français : . . . . . . . . . . . .4Instrucciones en español: . . . . . . . . . . .8SBSD227FGGGranite Pedestal BaseFor Washer Models: GBVH6260, GCVH6260,WCVH6260, WBVH6240, WHDVH626For Dryer Models: DCVH515, DHDVH52, DBVH512BEFORE YOU BEGINRead these instructions completelyand carefully.• IMPORTANT — Save theseinstructions for local inspector’s use.• IMPORTANT — Observe allgoverning codes and ordinances.• Note to Consumer – Keep theseinstructions with your Owner’s Manualfor future reference.• Completion time – 1 to 2 hours• Proper installation is the responsibilityof the installer.• Product failure due to improper installationis not covered under the Warranty.CAUTION — Due to the size andweight of these products, and to reduce therisk of personal injury or damage to theproduct, TWO PEOPLE ARE REQUIRED FORPROPER INSTALLATION.• See washer and dryer installationinstructions for additional installationrequirements and guidelines.InstallationInstructions