GE SPM Series Instruction Manual
Also see for SPM: Instruction manual
                                                                                                                              | |
Contents
|
2- 2SPM Synchronous Motor Protection & Control GE Power Management2.2 MECHANICAL INSTALLATION 2 INSTALLATION22.2 MECHANICAL INSTALLATION 2.2.1 UNPACKING THE SPMWhen the SPM is shipped separately, carefully unpack the module and report any observable damage or miss-ing components to the carrier and to GE Power Management. All included parts are shown in Figure 2–1:EXPLODED VIEW OF THE SPM on page 2–1.2.2.2 REMOVING THE DRAWOUT RELAY1. Remove the faceplate assembly carefully by pushing in on the quick release tabs on the front of the SPMand pulling the faceplate assembly forward. Once the faceplate has pivoted forward, gently lower the face-plate so that it clears the tabs on the bottom of the frame.DO NOT let the faceplate assembly dangle from the connecting wires.2. Carefully disconnect the ribbon cable from the cradle assembly.3. Remove the paddle and open the top and bottom locking tabs. The relay can now be removed from thecase.2.2.3 INSERTING THE DRAWOUT RELAY1. Slide the relay into the case and close the top and bottom locking tabs.2. Insert the paddle into the opening at the bottom of the relay.3. Carefully re-connect the ribbon cable to the cradle assembly.DO NOT shift or skew the ribbon connector.4. Re-mount the faceplate assembly to the case from the front panel. Slide the faceplate onto the tabs on thebottom of the frame and then pivot it up into position over the quick release tabs. The faceplate shouldgently snap into place.2.2.4 MOUNTING THE SPMMounting the SPM requires careful attention to the following instructions.DE-ENERGIZE ALL EXISTING EQUIPMENT BEFORE INSTALLING NEW EQUIPMENT.1. Remove the relay from the case.2. Prepare the mounting hole in the panel to dimensions shown in Figure 2–2: PHYSICAL DIMENSIONS.3. Slide the case into the panel from the front.4. Install the four mounting screws from the rear of the panel. The case is now securely mounted and readyfor panel wiring.2.2.5 SPM MOUNTING ACCESSORIESSee Chapter 8: ACCESSORIES for physical dimensions and mounting requirements.NOTENOTECAUTION |
Related manuals for GE SPM
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine