GROUNDING INSTRUCTIONSThis appliance must be grounded.In the event of an electrical short PREFERREDMETHODcircuit, grounding reduces the risk Iof elect~c shock by providing anescape wire for the electric current.This appliance is equipped with apower cord having a grounding Ensure proper groundwire with a grounding plug. The Fia. 1 exists before useplug must be plugged into an outlet I “that is properly installed and Consult a qualified electrician orgrounded. (Fig. 1) service technician if the groundingwARNING–Imm-o~erinstructions are not completelyunderstood, or if doubt exists as toILuse of the grounding plug can whether the appliance is properlyresult in a risk of electric shock. grounded.Where a standard 2-prong wallreceptacle is encountered, it isyour personal responsibility andobligation to have it replaced witha properly grounded 3-prong wallreceptacle.Do not under any circumstancecut or remove the third (ground)prong from the power cord.Do not use an adapter plug withthis appliance.Do not use an extension cordwith this appliance.7THE EXHAUST FEATUREThe exhaust hood feature on your microwave oven is equipped with twometal filters which collect grease. When the fan is operated, air is drawnup through the filters and is then discharged through the provided ventingto the outside.LIGHTReusable Grease FiltersThe grease filters should be cleaned at least once a month. Neveroperate the microwave without the filters in place. In situations whereflaming might occur on surfaces below hood, filters will stop the entryof flames into the unit.To Remove Grease Filter To Clean and Replace Grease FilterTo remove grease filter, To clean grease filter, soak it and then agitate filtergrasp the “finger hold” in solution of hot water and detergent. Don’t useon the filter and slide to ammonia or ammonia products because they willthe rear. Then pull filter darken the metal. Light brushing can be used todownward and to the remove embedded dirt.front. The filter willdrop out. Rinse, shake and remove moisture before replacing.To replace grease filter, slide the filter in the frameslot on the back of the opening.Pull filter upward and to the front to lock into place.(continued next page)31——