14Switching on1 Set the required heating mode using the functionselector. The chosen heating mode and thedefault temperature are displayed.2 If you want to change the default temperature:set the required temperature with the rotaryselector.The preheating symbol ’ appears on the display.The bar continuously shows the preheating status.When the set temperature is reached, a signal soundsand the preheating symbol ’ goes off.Note: The oven interior lighting stays switched off at atemperature setting below 70°CSwitching off:Turn the function selector to 0.Rapid heatingWith the "Rapid heat-up" function, your appliancereaches the desired temperature particularly quicklyin the top heating, bottom heating and top/bottomheating types of heating.To ensure an even cooking result, do not place yourfood in the cooking compartment until "Rapid heat-up"is complete and the ’ heat-up symbol goes out.Note: The "Rapid heat-up" function is preset in thefactory settings. In the basic settings, you can select’ Rapid heat-up or “ Heat-up.Safety shut-offFor your protection, the appliance is equipped with anautomatic safety shut-off. Any heating process isswitched off after 12 hours if the oven is not operatedin this time. A message appears in the display.Exception:The long-term timer has been programmed.Set the function selector to 0, then the appliance canbe operated again as usual.Timer functionsYou use the timer menu to make the following settings:Š Short-term timerp Stopwatch6 Cooking time (not in standby mode)5 Cooking time end (not in standby mode)Calling up the timer menuYou can call up the timer menu from any mode. Onlyfrom the basic settings, function selector is set to S,the timer menu is not available.Touch the M symbol.The timer menu is displayed.TimerThe timer runs independently of the other appliancefunctions. You can enter a maximum of 90 minutes.Setting the timer1 Call up timer menu.The "Timer" Š function is displayed.2 Turn the rotary selector to set the requiredcooking time.3 Start with I.7LPHU