308 The first rinsing process is displayed. Start withI. The appliance is rinsed. The rinsing timecounts down on the display.9 A signal sounds after 1 minute. Empty theevaporator dish with the cleaning sponge.Confirm with ™.10 The second rinsing process is displayed. Startwith I. The appliance is rinsed. The rinsing timecounts down on the display.A signal sounds after 1 minute. The descalingprogramme is complete.Empty the evaporator dish with the cleaning sponge.Empty the water tank and leave it to dry with the lidopen. Wipe the cooking compartment dry with a softtowel and use the drying programme to drycompletely.Delete the descaling hint on the display.Deleting the descaling hint1 Set the function selector to S. Use the rotaryselector to select "¥ Delete descaling hint".Confirm with ™.2 A note is displayed. Confirm with ™.Notes‒ The descaling programme must always runcompletely and can not be cancelled.‒ Before cooking, remove any descaler residuefrom the cooking compartment.‒ If the descaling programme was cancelled due toa power cut, it must be restarted before using theoven again in order to remove any descalerresidues from the appliance.Removing slide-in railsYou can remove the slide-in rails for cleaning.Detaching the rails1 Place a dish cloth in the cooking compartment toprotect the stainless steel against scratches.2 Undo the knurled nuts (Figure A).3 Pull away the slide-in rails slightly sideward fromthe screw and pull it out toward you (Figure B).Clean the rails in the dishwasher.Attaching the rails1 Position the slide-in rails correctly with thestopper at the back.2 Push the slide-in rails onto the bolt at the rear andthen hook them in at the front.3 Tighten the knurled nuts.Note: If you should lose a knurled nut, you can order itas a spare part from our after-sales service. Usingknurled nuts other than the original ones will causecorrosion in the oven interior.5LQVLQJSURFHVV_$ %