Gaggenau BX 481 Instruction Manual

Also see for BX 480: Instruction manual Installation instructions Use and care manual Use and care manual

Gaggenau BX 481 Instruction Manual Manual pdf 14 page image

14Setting the heating function andtemperatureYou can operate both ovens simultaneously withdifferent settings.Exception: When the Pyrolytic mode (Self-cleaningcycle) is being used in one oven, the other oven cannotbe operated.1 Select the desired type of heating using thefunction selector.Left function selector: Main ovenRight function selector: Top ovenThe selected type of heating and the defaulttemperature are shown in the display.For example: Main oven, Hot air, 170 °C.2 Turn the rotary selector to set the desiredtemperature.The “ heat-up symbol appears in the display. The barscontinuously display the heating status. When the settemperature has been reached, a signal sounds and the“ heat-up symbol goes out.Note: If the temperature setting is lower than 70 °C, thecooking compartment light remains switched off.If both ovens are switched on, the settings for bothovens appear in the display. Using Q or R, you canselect the corresponding oven display for a fewseconds; using P, you can return to the display for bothovens.Switching off:Turn the function selector to 0.Rapid heatingWith the "Rapid heat-up" function, your appliancereaches the desired temperature particularly quickly inthe top heating, bottom heating and top/bottom heatingtypes of heating.To ensure an even cooking result, do not place yourfood in the cooking compartment until "Rapid heat-up"is complete and the ’ heat-up symbol goes out.Note: The "Rapid heat-up" function is preset in thefactory settings. In the basic settings, you can select ’Rapid heat-up or “ Heat-up.Safety shut-offFor your protection, the appliance is equipped with anautomatic safety shut-off. Any heating process isswitched off after 12 hours if the oven is not operated inthis time. A message appears in the display.Exception:The long-term timer has been programmed.Set the function selector to 0, then the appliance can beoperated again as usual.43344 55