29TroubleshootingApplianceIceMakerFault Possible cause Remedial actionAppliance has no cooling capacity.The interior light does not function.The display does not come on.Power failure; the fuse has actuated;the mains plug is not in properly.Check that the power is on.The fuse must be switched on.Check that the mains plug is plugged in.The refrigerating unit switches on moreand more frequently and for longer.Appliance door opened frequently. Do not open the door unnecessarily.Large quantities of fresh food placedin the appliance.Switch on FAST COOLING/FASTFREEZING function.The ventilation openings are covered. Remove obstacles and dirt.The temperature in the freezercompartment is too cold.Temperature has been set too low. Set a warmer temperature(see “Setting the temperature”).The appliance becomes slightly louderfor a brief period.Not a fault! Your appliance is designed to save energy. Under certain conditions(e.g. activation of the FAST COOLING/FAST FREEZING function) the appliance mustwork harder for a brief period and therefore becomes slightly louder.The interior light does not function. The bulb is defective. Change the bulb(see “Changing the bulb”).The light switch is sticking. Check whether it can be moved.The appliance is giving off odors. Strong-smelling foods have not beenpacked in airtight containers.Clean the appliance. Pack strong-smellingfoods in airtight containers (see “Odors”).Fault Possible cause Remedial actionIce maker does not appearto be running.The ice maker is not connectedto the power supply.Call customer service.The ice maker has no water supply. Ensure that the water supply lineis connected properly.The freezer compartment temperature istoo high.Check temperature of the freezercompartment. If required, lowerthe temperature.Small ice cubes over a prolongedperiod.Other domestic appliances whichuse water are in operation.The ice maker has no water supply.Water filter must be changed. Instructions for changing the waterfilter can be found in the section"Water filter".Wrong water pressure. Check water pressure. The waterpressure must be between 25 and120 p.s.i. (1.72–8.25 bar).A wrong water valve has been installed. Self-tapping valves and 3/16 inch (4.76 mm)saddle valves reduce the water pressureand may eventually block the pipe.The manufacturer is not liable for damage to property due to an incorrectinstallation or water connection.