30Fault Possible cause Remedial actionIce cubes have an unpleasantodor/flavor.Ice which is stored for a long time mayabsorb odors which impair their taste.Dispose of old ice cubes. Use the icemaker more frequently.The ice cube container is dirty. Empty and wash out the ice cubecontainer.Unsealed packages in the freezer transferodor/flavor particles to the ice cubes.Check whether the frozen food has beenpacked in airtight containers.Clean the inside of the appliance. See section on "Odors".Ice maker is not producing any ice. The ice cube container is in the falseposition.Reinsert the container and slideit backwards to the end position(see section "Variable interior design").The water pressure is too low. Check water pressure. The waterpressure must be between 25 and120 p.s.i. (1.72–8.25 bar).The freezer compartment temperature istoo high.Check temperature of the freezercompartment. If required, lowerthe temperature.A wrong water valve has been installed. Self-tapping valves and 3/16 inch (4.76 mm)saddle valves reduce the water pressureand may eventually block the pipe.The manufacturer is not liable for damage to property due to an incorrectinstallation or water connection.The ice maker is not producing enoughice or the ice cubes are misshapen.The water pressure is too low. Check water pressure. The waterpressure must be between 25 and120 p.s.i. (1.72–8.25 bar).The freezer compartment temperature istoo low.Check temperature of the freezercompartment. If required increasethe temperature.Change the water filter. Instructions for changing the water filtercan be found in the enclosed installationinstructions.Ice is forming in the supply hose to theice maker.The water pressure is too low. Check water pressure. The waterpressure must be between 25 and120 p.s.i. (1.72–8.25 bar).The freezer compartment temperature istoo high.Check temperature of the freezercompartment. If required increasethe temperature.Water is flowing out of the appliance.– Close shut-off valve immediately.The water pipe in the applianceis defective.Call customer service immediately.The water pressure is too low. The valve may leak if the water pressure istoo low. The water pressure must bebetween 25 and 120 p.s.i. (1.72–8.25 bar).A wrong water valve has been installed. Self-tapping valves and 3/16 inch (4.76 mm)saddle valves reduce the water pressureand may eventually block the pipe.The manufacturer is not liable for damage to property due to an incorrectinstallation or water connection.