Gaggenau RB472704 Instruction Manual

Also see for RB472704: Instruction manual Installation instructions

18en-us Operating the applianceSwitching ice cube production on or off9 CAUTIONDamage to the appliance!Never store bottles or food in the ice cubecontainer, even for short periods. This can blockand damage the ice maker.Ice cube production starts as soon as the appliance hasreached the set temperature.Note: Ice cube production stops automatically when theice cube container is full.Switching ice maker on or off1. Press à button to open the main menu.2. Press C button to move to the menu item Ice cubeproduction.3. Press I/& button.Eco modeEco mode switches the appliance to energy-savingoperation.The appliance automatically sets the followingtemperatures:▯ Refrigerator compartment: +43 °F (6 °C)▯ Freezer compartment: +3 °F (–16 °C)Switching Eco mode on or off1. Press à button to open the main menu.2. Press C button to move to the menu item Eco mode.3. Press I/& button.The temperature is changed, and the display shows thenew temperature. When Eco mode is switched off, therecommended temperature is set.Note: You can also switch Eco mode on or off byadjusting the temperature with A/@ buttons.Reset water filter counterAfter replacing the water filter, you have to reset thewater filter counter.1. Press à button to open the main menu.2. Use C button to move to the menu item Reset waterfilter counter.3. Use ™ button to confirm and confirm the query againwith ™ button.Note: The water filter counter will not be reset if youabort the query or take longer than 10 seconds to makean input.Self-testThis function can be used to start fault analysis on yourappliance.~ "Appliance self-test" on page 33Setting the brightness of the controlpanel1. Press à button to open the main menu.2. Press B button to move to the menu item Basicsettings.3. Press ™ button.4. Press % button to open the menu item Brightness.5. Press B C buttons to set the required brightness.6. Press ™ button.The setting is saved.7. Press ' button to exit the menu.Setting the display screenYou can choose between the settings Reduced andStandard. With the setting Reduced only the temperatureand active special functions are displayed on the controlpanel after a short period without operation. If the touchfields are touched, all keys will be visible again.With the setting Standard all keys always remain visible.1. Press à button to open the main menu.2. Press B button to move to the menu item Basicsettings.3. Press ™ button.4. Press C button to move to the menu item Displayscreen.5. Press % button.6. Press B C buttons to move to the required setting.7. Press ™ button.The setting is saved.8. Press ' button to exit the menu.