Gaggenau RY 492 Installation Instructions Manual

Also see for RY 492: Operating instructions Instructions for use Installation instructions

Gaggenau RY 492 Installation Instructions Manual Manual pdf 13 page image

132. Attaching alternative anti-tilt deviceImportant note:If the anti-tilt brackets cannot be securely attached,a wooden beam can be used above the appliance as analternative anti-tilt device. Care should be taken thatthere is not a gap between the appliance and thewooden beam. As far as possible, always screw thewooden plank to the rear wall of the niche.1. Saw the wooden beam (cross section min. 3" x 4")to the required length. Length is equal to the widthof the installation niche!Notes:– If the installation niche is deeper than theappliance, select a beam which has a largercross section or attach 2 beams.– The beam must cover the appliance by at least 2"(50.8 mm).2. Mark the installation height (lower edge of the beam)on the rear panel of the installation niche.3. Select screws according to the thickness of thewooden beam: length = min. 2.5 x beam thickness,diameter #12 or #14.Note:Choose the number of screws according to theinstallation niche width, thereby ensuring that thebeam can be attached securely.4. Depending to the subsurface:Locate wall studs in the rear of the installation nicheand accordingly transfer their location to the woodenbeamorfasten suitable dowel into the rear wall.5. Predrill the wooden beam.6. Attach the wooden beam to the rear panel of theinstallation niche.3. Attaching the edge protectorsTo protect the edges of the installation niche, it isrecommended to attach edge protection made ofa suitable material.Attach the edge protection with the adhesive tape whichwas used to attach the accessories to the appliance.4. Attaching the fastening sheet(lateral)Attach the fastening sheet (lateral) to the appliance.The following are special installationsteps. Instructions are provided aftersection D.– Water connection see “Preparing thewater connection”.