Gaggia Anima Service Manual

Also see for Anima: Operating instructions Operating instructions Operating instructions

GAGGIA ANIMA 05 TROUBLESHOOTINGPag. 2/9Verify the firmware versionVerify the firmware versionPage 0 (FIRMWARE)Page 0 (FIRMWARE)Firmware version on the display.Firmware version on the display.The machine model is shownThe machine model is shown (Focus ⇒CMF, Class ⇒AMF, Top ⇒OTC)..The voltage of the main supply “230V”The voltage of the main supply “230V”The frequency of the main supply is shown (50 or 60 Hz)The frequency of the main supply is shown (50 or 60 Hz)The firmware version is the same as the label on MicroControllerThe firmware version is the same as the label on MicroControllerERROR: The firmware version is different from the label on MicroController;change the CPU_POWER Boards !ERROR:ERROR: If in machine model field is written “Unknow” and backlight of display is Red, check theIf in machine model field is written “Unknow” and backlight of display is Red, check thejumper in interface.jumper in interface.The machine passes to the Page 1 (KEYBOARD)The machine passes to the Page 1 (KEYBOARD)ERROR: The page does not change; Check the interface board andthe flat cable (JP21)PressPress Z7Z7 ““ ” to move to the next screen” to move to the next screenPage 5: High voltage loads test (Heater , Grinder ):a) Heater (230V AC)b) Grinder (320V DC)The user can change the page by pressing the Z7 button.Page 0 is accessible only entering Test Mode from power-off mode; at the start up all loads areturned off.TEST MODE Level0TEST MODE Level1TEST MODE Level2TEST MODE Level3TEST MODE Level4TEST MODE Level5Pressing button Z7Pressing button Z7Pressing button Z7Pressing button Z7Pressing button Z7Pressing button Z7