Gardena EasyCut 400/25 Operator's Manual

Also see for EasyCut 400/25: Operating instructions

Contents

EN95. Pull the plastic ring h back over the filament cassette g.6. Reinstall the filament cassette g as described under 5. MAINTENANCE“Replacing the filament cassette”.Problem Possible Cause RemedyThe trimmer no longer cuts Filament worn or too short. v Lengthen the filament(see 3. OPERATION“Filamentfeed – Tip mechanism”).The trimmer no longer cuts Filament cassette empty. v Replace the filament cas sette(see 5. MAINTENANCE“Replac ing the filamentcassette”).Filament drawn into thecassette or stuck together.v Pull the filament out of thefilament cassette (see above).Filament cannot beextended or filamentis consumed rapidlyThe filament became too dryand brittle (e. g. over the winter).v Place the filament in waterfor approx. 10 hours.Frequent contact between thefilament and hard objects.v Avoid contact between thefilament and hard objects.NOTE: For any other malfunctions please contact the GARDENA service depart-ment. Repairs must only be done by GARDENA service departments or specialistdealers approved by GARDENA.7. TECHNICAL DATATurbotrimmer Unit Value (Art. 9807)Motor power consumption W 400Mains voltage /Mains frequency V / Hz 230 / 50 – 60Filament thickness mm 1.6Cutting width mm 250Filament supply m 6Filament feed Tip mechanismRpm of filament cassette(approx.) rpm 12,000Weight (approx.) kg 2.9Telescopic adjustment ofthe turn handle (approx.) cm 24Sound pressure level LpA1)Uncertainty kpAdB (A) 803Sound power level L WA2):measured/guaranteedUncertainty k WAdB (A) 92 / 953Hand/arm vibration a vhw3)Uncertainty kam/s2 31.5Measuring process complying with: 1) DIN EN 60335-2-91 2) RL2000/14/EG 3) DIN EN 786.NOTE: The stated vibration emission value has been measured according toa standardized test procedure and can be used for comparison of one electricpower tool with another. It can also be used for preliminary evaluation ofexposure. The vibration emission value can vary during actual use of the electric powertool.8. SERVICE / WARRANTYService:Please contact the address on the back page.Warranty:In the event of a warranty claim, no charge is levied to you for the servicesprovided.GARDENA Manufacturing GmbH offers a two-year warranty (effectiveas of the date of purchase) for this product. This warranty includes allsignificant defects of the product that can be proved to be material ormanufacturing faults. This warranty is fulfilled by supplying a fully functionalreplacement product or by repairing the faulty product sent to us free ofcharge; we reserve the right to choose between these options. This ser-vice is subject to the following provisions:• The product was used for its intended purpose as per the recommen-dations in the operating instructions.• Neither the purchaser nor a third party has attempted to repair theproduct.This manufacturer’s warranty does not affect warranty entitlements againstthe dealer / retailer.If problems arise with this product, please contact our Service depart-ment or send the defective product along with a brief description of thefault to GARDENA Manufacturing GmbH, making sure to have sufficientlycovered any shipping costs and to have followed the relevant postageand packaging guidelines. A warranty claim must be accompanied bya copy of the proof of purchase.Consumables:The filament cassette and cassette cover are consumables and are notcovered by the guarantee.

/ 9

Related manuals for Gardena EasyCut 400/25