Garland IR36-280L Installation & Operating Manual

Contents

Garland IR36-280L Installation & Operating Manual Manual pdf 13 page image

Part # 1382669 (07/05) Page 132. Insert a thin bladed screwdriver into the valve stemto engage the slot inside the stem. Turn clockwiseto decrease the rate and counter-clockwise toincrease.Proper adjustment is attained at the point where theburner rods no longer glow and the flame travels backand forth on the face of the ceramics.OPERATION ContinuedThis adjustment has been factory pre-set, however, withchanging pressures this adjustment and pilot adjustmentmay need to be re-done after installation.This is not considered a manufacturing defect and isnot warrantable.MAINTENANCE AND CLEANINGA program of proper cleaning techniques will aid incontinued trouble free operation of this or any qualityequipmentDailyGrid racks should be wiped daily while still warm,using a heavy cloth or other grease absorbing materialto remove grease and burnt food before they burn intothe grid. Remove burnt materials, such as carbonizedgrease or food, with a stiff wire brush. DO NOT USEANY TYPE OF STEEL WOOL. Small particles maybe left on the grid surface and get into food products.Grid racks should be washed thoroughly using a wirebrush and a hot, mild detergent or soap solution. Rinsewith clear, warm water.MonthlyLubricate valves and bearings as required. Due to theusual location of the broiler that is mounted above arange with open tops, the heat from the open top willcause the lubrication grease inside the valves to dry out.When you notice that the valve is becoming harder toturn it is then time to have them greased. We suggestan Authorized Service Agent who is familiar with theappliance and working with natural and propane gas,to perform this type of work.Exterior CleaningEstablish a regular schedule. Any spills should be wipedoff immediately.1. Wipe exposed, clean-able surface when cool witha mild detergent and hot water. Stubborn residuespots may be removed with a light weight non-metallic scouring pad. Dry thoroughly with a cleancloth.2. Stainless steel should be cleaned using a milddetergent, a soft cloth and hot water. If it is necessaryto use a non-metallic scouring pad, always rub inthe direction of the grain in the metal to preventscratching. Use a water based stainless steel cleaner(such as Drackett Twinkle), if you want a highshine.

/ 16

Related manuals for Garland CM36-280