Garland MASTER SERIES XG24CE GB/IE Installation & Operation Manual

Also see for MASTER SERIES XG24CE GB/IE: Instruction manual Installation and operation manual

Part # 4517127 (06/23/08)Page 10GRILL CONTROLSMaster Power Switch:Controls power to the grill and must be turned “ON” to startoperation. The controller display will be active when theswitch is “ON”.Indicator Lights:There are two, (2), indicator lights, indicating thetemperature status of each control’s heat zones; one, (1), onthe upper platen, (top light), and one, (1), on the grill surface.Each light can display three, (3), different colors, indicatingtemperature status for the corresponding zone.Red: The zone is too hot, (more than 79°F/45°C over the settemperature), or heat zone failure.Amber: The zone is calling for heat.Green: The zone is at or above the set temperature.Display:The controller display will contain information relevant toeach operation in both cook and program modes.Gap Setting Buttons (1-5):For two-sided recipes, the desired gap button is pressedbefore the cook cycle begins to set the gap. Hold buttons1-5 to apply gap settings 6-10. The chosen gap button andits value will be displayed. Until a different menu item isselected, (or the current item is changed and then returnedto), the Gap Button only needs to be pressed before theinitial cook.Gap Button:When in programming mode, press the Gap Button to setthe values for Gap Buttons 1-10. Press Enter to accept thechanges. After going through all ten, you will return toProgramming Mode.GAPSETTINGBUTTONSGAPBUTTONDISPLAYREADYINDICATORSWHEN PUSHED SIMULTANEOUSLY:"START COOK TIME COUNTDOWN" (flat grill cooking)OR "LOWER PLATEN" (two-sided cooking)POWERBUTTONMASTERPOWERSWITCHONOFFENTERBUTTONPROGRAMBUTTON DOWN ARROWBUTTONTEMPERATUREBUTTON UP ARROWBUTTONCANCEL/RAISE PLATENBUTTON