Garland MASTER SERIES XG24CE GB/IE Installation & Operation Manual

Also see for MASTER SERIES XG24CE GB/IE: Instruction manual Installation and operation manual

Part # 4517127 (06/23/08)Page 20To View the Flash Number:1. Press and hold for three, (3) seconds. “ENTER CODE”will be displayed.2. Using the Gap Setting buttons, enter thecode, (1251). “ENTER CODE **** ” will be displayed.3. Press to enter the Programming Mode.“PROGRAMMING MODE MENU ITEMS” will be displayed.4. Press one, (1) time to display “PROGRAMMING MODESYSTEM INFO.”5. Press four, (4), times to view the Flash Number. “FLASHNUMBER X…X” will be displayed. (Flash number varies bygrill).6. Press to return to “PROGRAMMING MODE SYSTEMINFO”.7. Press to exit.To View the Software Number:1. Press and hold for three, (3) seconds. “ENTER CODE”will be displayed.2. Using the Gap Setting buttons, enter thecode, (1251). “ENTER CODE **** ” will be displayed.3. Press to enter the Programming Mode.“PROGRAMMING MODE MENU ITEMS” will be displayed.4. Press one, (1) time to display “PROGRAMMING MODESYSTEM INFO.”5. Press five, (5), times to view the Software Number.“SOFTWARE NUMBER X…X” will be displayed. (numbervaries by grill).6. Press to return to “PROGRAMMING MODE SYSTEMINFO”.7. Press to exit.To View the Download Number:1. Press and hold for three, (3) seconds. “ENTER CODE”will be displayed.2. Using the Gap Setting buttons, enter thecode, (1251). “ENTER CODE **** ” will be displayed.3. Press to enter the Programming Mode.“PROGRAMMING MODE MENU ITEMS” will be displayed.PROGRAMMING continued4. Press one, (1) time to display “PROGRAMMING MODESYSTEM INFO.”5. Press six, (6), times to view the Download Number.“DOWNLOAD NUMBER X…X” will be displayed.(Download number varies by grill).6. Press to return to “PROGRAMMING MODE SYSTEMINFO”.7. Press to exit.System SetupTo Change temperature Units, (°F or °C):1. Press and hold for three, (3) seconds. “ENTER CODE”will be displayed.2. Using the Gap Setting buttons, enter thecode, (1251). “ENTER CODE **** ” will be displayed.3. Press to enter the Programming Mode.“PROGRAMMING MODE MENU ITEMS” will be displayed.4. Press two, (2) times. “PROGRAMMING MODE SYSTEMSETUP” is displayed.5. Press to enter system setup. “TEMP DISPLAYFAHRENHEIT (or CELSIUS)” will be displayed.6. Press to change the temperature units to eitherFahrenheit or Celsius.7. Press to save the changes.8. Press to return to “PROGRAMMING MODE SYSTEMSETUP”9. Press again to exit.To Change Gap Setting Display Units:1. Press and hold for three, (3) seconds. “ENTER CODE”will be displayed.2. Using the Gap Setting buttons, enter thecode, (1251). “ENTER CODE **** ” will be displayed.3. Press to enter the Programming Mode.“PROGRAMMING MODE MENU ITEMS” will be displayed.4. Press two, (2) times. “PROGRAMMING MODE SYSTEMSETUP” is displayed.5. Press two, (2), times. “GAP SETTING DISPLAY INCHES(or MILLIMETERS)” will be displayed.