Garland MPOE5L Installation And Operating Instructions Manual

Also see for Moisture+ MPOE5L: Service manual

Contents

Part # 4518084 Rev. 1 (09/04)Page 10OPERATING INSTRUCTIONS continued...9. The display will then ask if you would like tocontinue programming for this product. Pressthe “YES” (upper right blank) button to programadditional profiles (profile 2-6). Press the “NO”(Preheat Bread 425) button to exit programmingfor this product.• NOTE: If programming additional profiles, repeatsteps 3-9 for each profile (Prof2 - Prof6).10. The Display will ask for the Product Name(selectable from a library of 40 names). Press the“YES” (upper right blank) and “NO” (PreheatBread 425) buttons to scroll through the availablenames and press “ENTER” (lower right blank) toaccept the desired name. The product LED will goout.• NOTE: Upon pressing “ENTER” (lower rightblank) to accept the product name, you will return torecipe programmingSystem Programming• NOTE: System Programming can only be enteredwhen the control is in the idle or off state (SystemProgramming cannot be entered when the timer iscounting down)1. To enter System Programming, press and hold theProgram (lower-right blank) button for three, (3),seconds. When prompted, enter the code: 4-2-7-6 using the buttons 1 – 0. Press “ENTER” (lowerright blank).2. After entering the code and pressing “ENTER,”the control Flash Number will be displayed. Press“ENTER” (lower right blank) to continue.3. Next, the Software Number will be displayed.Press “ENTER” (lower right blank) to continue.4. Next, the control Download Number will bedisplayed. Press “ENTER” (lower right blank) tocontinue.5. The display will now show the SCK Address. Usethe buttons 1 – 0 to enter the desired address.When finished, press “ENTER” (lower right blank)to continue.6. The display will now show Ignition Test. Thisis primarily used in manufacturing only. Press“ENTER” (lower right blank) to continue.7. Lastly, the control will perform a Display Test. Theentire display and all of the control LED’s will flash.If any part of the display or any of the LED’s donot light, there is a problem with the control board.Press “ENTER” (lower right blank) to continue.8. You will now return to the control Flash Number.Press “CANCEL” to exit System Programming.