Garland MPOE5L Installation And Operating Instructions Manual

Also see for Moisture+ MPOE5L: Service manual

Contents

Part # 4518084 Rev. 1 (09/04)Page 14CLEANING AND MAINTENANCECheck CalibrationTools: Digital thermometer with probe; oven mitt.See also, Temperature Calibration on page 12.1. Clamp the probe in the center of the middle rack.2. Pass the probe wire out of the oven between thedoor and the door seal and close the door.3. Plug the probe wire into the thermometer.4. Press the oven On/Off button.5. Press the “Preheat Bakery 350” button to heatthe oven to 350°F. Allow the oven to preheat forapproximately 30 minutes before calibrating.Break in PeriodWhen the oven is new, heat the oven to “PreheatBread 425), and leave the oven idle for one hour beforebeginning normal operation.Oven CleaningExterior• NOTE: Disconnect the oven from the power supplybefore cleaning or servicing.• Establish a regular cleaning schedule. Any spillsshould be wiped off immediately.Tools: Mild detergent; hot and warm water; spongeor soft cloth; clean, dry cloth; possible non-metallicscour pad; possible scouring powder.1. The oven should be allowed to cool sufficientlybefore beginning the cleaning procedure.2. Wipe exposed cleanable surfaces when cool witha mild detergent and hot water. Stubborn residuespots may be removed with a lightweight non-metallic scouring pad. Dry thoroughly with a cleancloth.3. Painted surfaces should be cleaned using a mildsoap and warm water solution on a sponge or softcloth. Dry thoroughly.4. Stainless Steel surfaces may also be cleaned using amild soap and warm water solution on a sponge orsoft cloth. Stubborn stains may be removed using anon-metallic abrasive pad, rubbing in the directionof the metal’s grain. If necessary, for particularlyheavy spots, you may mix a thin paste of water andscouring powder, and apply it with a sponge. Becareful to apply light pressure and remember to rubonly in the direction of the metal’s grain.5. The control panel surface is easily cleaned withhot water, soap, and a soft cloth. Do not usehard abrasives, solvent type materials, or metallicscouring pads since these will scratch and cloud thesurface.6. Never spray the perforated areas or control panelwith steam or water as this will allow moistureto enter the control cavity, which could damageelectrical components.

/ 16

Related manuals for Garland Moisture+ MPOE5L