Garland SH DU IN 7000 Installation And Operation Manual

Installation RTCSmp Induction Built-In Line Dual Zone Cookers12 Part # 4532285 Rev 4 (4/29/14)4.3.2 Control Unit InstallationThe induction unit comes with two complete control units — one for the front cooking zone and one for the rearzone. Each control comes with a 36” (914mm) RJ-45 cable.NOTE Install the control units VERTICALLY on the cabinet panel. There are two methods to install a controlunit: front-mount or back-mount onto the panel.Installers are responsible for choosing the appropriate fasteners for the installation.4.3.2.1 Front-MountTo mount the control unitonto the front of the panel:1. Drill holes and make thecut-out using thedimensions and theactual unit provided.2. Secure the control unit tothe panel with fasteners.Illustration: Measurements inmm and [inch].4.3.2.2 Back-MountNOTE For this type of installation, the maximum thickness of the panel must not exceed 1.5mm or 16 gauge.This restriction ensures a proper grip on the knob and the LED light will not be obstructed.To mount the control unitonto the back of the panel:1. Drill holes on the panel usingthe dimensions provided.2. Remove the plastic knobfrom the control unit andattach the control unit to thepanel with fasteners asshown. NOTE: DO NOTremove or loosen anyscrews on the control unit.Illustration: Measurements in mmand [inch].Front PanelFront Panel12 [ .474]10.11 [ .398]11.91 [ .469]maximum1.5 [0.06]