190-01700-00 Flight Stream 110/210 TSO Installation ManualRev. B Page 2-22.3 Special Tools RequiredTable 2-2. Pin Contact NumbersTable 2-3. Recommended Crimp ToolsNOTENon-Garmin part numbers shown are not maintained by Garmin and are subject tochange without notice.2.4 Cabling and WiringWiring should be installed in accordance with AC 43.13-1B Chapter 11. When wire separation cannot beachieved, the following issues should be addressed:• The cable harness should not be located near flight control cables, high electrical capacity lines, orfuel lines.• The cable harness should be located in a protected area of the aircraft.• Do not route cable near high-energy sources.See the interconnection diagrams in appendix B for the appropriate wiring. Once the cable assemblies havebeen made, attach the cable connector. Route the wiring bundle as appropriate. Avoid sharp bends.For the Flight Stream, use 22 AWG wire for all connections including power/ground.CAUTIONCheck wiring connections for errors before connecting the 15-pin D-sub to the FlightStream. Incorrect wiring could cause component damage.2.5 Mounting RequirementsThe Flight Stream may be mounted in a pressurized or unpressurized location. To achieve optimalBluetooth reception, mount the Flight Stream as close as possible to the cockpit.Wire Gauge 15-pin connectors20-24 AWGGarmin P/N 336-00021-00Military P/N M39029/58-360Wire Gauge Hand Crimping Tool20-24 AWGPositioner Insertion/ExtractionToolMilitary P/N M22520/2-01 M22520/2-09 M81969/1-04Positronic 9507 9502-4 M81969/1-04AMP 601966-1 601966-6 91067-1Daniels AFM8 K42 DAK95-22MB/DRK95-22MBAstro 615717 615725 M81969/1-04