Garmin Flight Stream 110/210 Installation Manual
                                              | |
Contents
|
190-01700-00 Flight Stream 110/210 TSO Installation ManualRev. B Page 3-13 INSTALLATION PROCEDUREThis section provides hardware equipment information for installing the Flight Stream. For interconnectswith interfaced equipment, see appendix B.3.1 Wiring Harness InstallationAllow adequate space for installation of cables and connectors. All electrical connections are madethrough a 15-pin D-sub connector provided by Garmin. Construct the wiring harness according to theinformation contained in this and the following sections. Cable lengths will vary depending uponinstallation.1. Strip all wires going to the D-sub connectors 0.17".2. Insert the wire into the pin and crimp with one of the recommended (or equivalent) crimping tools.3. Insert the pin into the D-sub connector housing locations as specified by the interconnect drawingin appendix B.4. Verify the pin is properly engaged into the connector by gently tugging on the wire.5. Route and secure the cable run from the Flight Stream to the other units away from sources ofelectrical noise.section 6 defines the electrical characteristics of all input and output signals. Required connectors andassociated hardware are supplied with the connector kit. See appendix B for interconnect wiring diagrams.3.2 Flight Stream Backshell Assembly and D-sub Connector3.2.1 Flight Stream Connector AssemblyTable 3-1. Connector and Backshell AssemblySee figure 3-1 Description Garmin P/N1 Screw, 4-40x.187, FLHP100, SS/P with Nylon 211-63234-062 Cover, Backshell, Jackscrew 115-01079-003 Screw, 4-40x.375, PHP, SS/P with Nylon 211-60234-104 Clamp, Backshell, Jackscrew 115-01078-005 Backshell, Jackscrew, 15 Pin 125-00171-006 Conn, HD D-Sub, 15 Pin 330-00626-15 |
Related manuals for Garmin Flight Stream 110/210
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine