Garmin G1000 Pilot's Manual

Also see for Cessna Caravan G1000: Cockpit reference guide Pilot's guide Pilot's guide Pilot's guide Pilot's guide

Contents

Garmin G1000 Pilot's Manual Manual pdf 416 page image

190-00498-01 Rev. AGarmin G1000 Pilot’s Guide for Cessna Nav IIIA-6APPENDIX ATIS VOICE ALERTSThe following voice alerts can be configured for ‘Male’ or ‘Female’ gender by using the Aux System Setup Page on theMFD.Voice Alert Alert Trigger“Traffic” Played when a Traffic Advisory (TA) isissued.“Traffic NotAvailable”Played when the traffic system fails or can-not communicate.NOTE: Voice alerts are provided to the G1000 by GIA 63/W #1. Should this unit fail, audio and voice alerts will nolonger be available.G1000 SYSTEM MESSAGE ADVISORIESThis section describes various G1000 system message advisories. Certain messages are issued due to an LRUor an LRU function failure. Such messages are normally accompanied by a corresponding red ‘X’ annunciationas shown previously in the G1000 System Annunciation section.NOTE: This Section provides information regarding G1000 message advisories that may be displayed by thesystem. Knowledge of the aircraft, systems, flight conditions, and other existing operational priorities mustbe considered when responding to a message. Always use sound pilot judgment. The Cessna Nav III Pilot’sOperating Handbook (POH) takes precedence over any conflicting guidance found in this section.MFD & PFD MESSAGE ADVISORIESMessage CommentsDATA LOST – Pilot stored data waslost. Recheck settings.The pilot profile data was lost. System reverts to default pilot profile and settings. Thepilot may reconfigure the MFD & PFD with preferred settings, if desired.XTALK ERROR – A flight displaycrosstalk error has occurred.The MFD and PFD are not communicating with each other. The G1000 system shouldbe serviced.PFD1 SERVICE – PFD1 needs service.Return unit for repair. The PFD and/or MFD self-test has detected a problem. The G1000 system should beserviced.MFD1 SERVICE – MFD1 needsservice. Return unit for repair.MANIFEST – PFD1 softwaremismatch. Communication halted. The PFD and/or MFD has incorrect software installed. The G1000 system should beserviced.MANIFEST – MFD1 softwaremismatch. Communication halted.PFD1 CONFIG – PFD1 configurationerror. Config service req’d. The PFD and/or MFD configuration settings do not match backup configurationmemory. The G1000 system should be serviced.MFD1 CONFIG – MFD1 configurationerror. Config service req’d.SW MISMATCH – GDU softwareversion mismatch. Xtalk is off.The MFD and PFD have different software versions installed. The G1000 systemshould be serviced.