Garmin G300 Pilot’s Guide 190-00921-00 Rev. D198integrated autopilotSystemOverviewFlightInstrumentsEISCOMInterfaceGPSNavigationFlightPlanningHazardAvoidanceAdditionalFeaturesIntegratedAutopilotAnnun/AlertsAppendixIndexInitial Bank Angle Autopilot Roll ReferenceLess than 6° Rolls wings level6° to Maximum Bank Setting Maintains current aircraft bank angleGreater than Maximum Bank Setting Limits bank angle to maximum bank settingRoll Hold Mode ResponsesCHANGING THE ROLL REFERENCETo adjust the roll reference while in Roll Hold Mode, hold the CWSButton, establish the desired bank angle, then release the CWS Button.heading mOde (hdg)Heading Mode is activated by pressing the AP HDG Softkey. HeadingMode acquires and maintains the Selected Heading. The Selected Headingis shown by a light blue bug on the HSI and Heading Tape and in the boxto the upper left of the HSI.Heading Mode AnnunciationCHANGING THE SELECTED HEADINGnOte: Press and hold the FMS Joystick (on the PFD or PFD Page) tosynchronize the Selected Heading to the current heading.Changing the selected heading (integrated autopilot config-ured):1) From the PFD Page (one display) or PFD (two display), press the HDG/ROLL Softkey (if necessary). The Heading Box is highlighted.2) Turn the FMS Joystick to select the desired heading, and press the ENTKey. The Selected Heading is shown to the left of the HSI.Holding the CWS Button and hand-flying the aircraft does not changethe Selected Heading. The Integrated Autopilot guides the aircraft back tothe Selected Heading upon release of the CWS Button.
