Garmin GHP 20 Marine Autopilot System with SmartPump Installation Instructions Manual

Also see for GHP 20 Marine Autopilot System for Steer-by-Wire: Product information Owner's manual Installation instructions

Contents

Garmin GHP 20 Marine Autopilot System with SmartPump Installation Instructions Manual Manual pdf 10 page image

L TRPL TRPÀ Steering cylindersÁ Port lineÂ Shutoff valvesÃ Return lineÄ PumpÅ Shadow DriveÆ Starboard lineÇ HelmsÈ Uflex MasterDrive power unitÉ High pressure line - DO NOT CUTInstallation ProceduresAfter you have planned the autopilot installation on your boatand satisfied all of the mounting and wiring considerations foryour particular installation, you can begin mounting andconnecting the components.CCU InstallationTo install the CCU, you must mount it to your boat (page 10),connect it to the pump (page 11), connect it to a NMEA 2000network (page 2), and connect it to the alarm (page 11).Installing the CCU Mounting BracketBefore you can mount the CCU, you must select a mountinglocation (page 1) and determine the correct mounting hardware(page 1).The CCU bracket has two portions, the mounting portion andthe securing portion.1 Use the mounting portion of the CCU bracket as a mountingtemplate.If you are installing the CCU on a vertical surface, install thebracket with an opening at the bottom, so that the cables canhang straight down and are not blocked by the mountinghardware À.2 Use a pencil to mark the pilot-hole locations at the mountinglocation.3 Drill the pilot holes.4 Use screws Á to secure the CCU bracket to the mountinglocation.Securing the CCU in the CCU Bracket1 Connect the CCU cable and the NMEA 2000 drop cable tothe CCU.2 Place the CCU in the CCU bracket with the wires À hangingstraight down .10