c. Fly the procedure turn. After the procedure turn outbound, set the inbound course onthe HSI.d. On the inbound intercept to the final course, fly to center the CDI.e. Set the GPS SEQ switch to the AUTO position. The GPS 165 will resume automaticwaypoint sequencing for the remaining approach waypoints.6. Once the aircraft is within 2 nm of the FAF (and the approach has been armed), the ‘ACTV’annunciator will illuminate and the CDI scale will ramp down to 0.3 nm.NOTE: If the ACTV annunciator does not illuminate, do not descend after crossing the FAFand fly all published missed approach procedures.7. Upon reaching the FAF, the GPS 165 will automatically sequence to the MAP waypoint.To fly a missed approach procedure:If an approach is terminated, the GPS 165 may be used to navigate to the missed approachholding point using one of the following procedures.NOTE: To comply with TSO specifications, the GPS 165 will not automatically sequenceto the missed approach holding point. The first waypoint of the missed approach will bedisplayed as the next D waypoint. After crossing the MAP, the pilot may activate thewaypoint when authorized. You must fly all published missed approach procedures beforeselecting the missed approach holding point on the GPS.If the approach procedure permits navigation direct from the MAP to the missedapproach holding point:1. Release the GPS SEQ switch from the ARM position to return the CDI scale to the 1 nmsensitivity. After the MAP has been crossed, press the D key. The GPS 165 will auto-matically display the first waypoint of the missed approach as the next approach waypoint.2. Press E to confirm the destination. The GPS 165 will provide a direct navigation courseto the waypoint.68APPROACH NAVIGATIONFlying the ApproachIf you have clearance directly to the holding point,press ENTER. You must fly all published missedapproach procedures before navigating to theholding point.After crossing the MAP, press the D key to dis-play the missed approach holding point.