You’ll now have a clearer picture of the route you are navigating. Keep in mind that whenever youdo exceed the usable range of the built-in database or the optional MapSource or BlueChart data in use,the range field displays ‘OVERZOOM’ to indicate that you should exercise extreme caution using themap data. Press the IN key to zoom into the 2 nm scale. Now that you’ve zoomed in a little closer toyour route, you can pan ahead of your vessel with the cursor to review map items and create on-screenwaypoints. Try moving the cursor to highlight the ‘TOUR3’ waypoint— just use the ARROW KEYPADto move the cursor as close as possible to the waypoint. (To move the cursor in small increments, try aseries of short key presses.)Once the cursor is over the TOUR3 waypoint, you’ll notice that the waypoint symbol and namebecomes highlighted. The data field at the top of the map displays the waypoint name, the range andbearing from your present position, and the coordinates for the waypoint.To review the waypoint page for a selected waypoint:1. With the waypoint highlighted, press the ENTER key.2. To return to the Map Page, press ENTER again or press QUIT.The cursor can also be used to create new waypoints right from the map display.To create a new waypoint using the cursor:1. Use the ARROW KEYPAD to move the cursor as close as possible to the following position:N35º 02.914; W 076º 26.152’ (Use the data window to verify the cursor position.)2. Press and release the ENTER key to capture the cursor position. Do not hold the button down, asdoing so marks your present position, not the map position.3. Use the ARROW KEYPAD to highlight the waypoint symbol field to the left of the waypoint name/number.4. Press ENTER to access the symbol page.5. Use the ARROW KEYPAD to select the ‘Shipwreck’ symbol and press ENTER to confirm.6. Highlight ‘OK’ at the bottom and press ENTER again to finish.The waypoint ‘highlights’when the cursor is movedover it.Waypoint numbering starts with001 and continually counts up,even if the waypoint name hasbeen deleted.Getting StartedReviewing/CreatingMap Waypoints